How can I convert netcdf file to a binary file in matlab?

Dear all, I have monthly nutrients data from WOA (in a separate NetCDF file) extracted for a specific region. I would like to convert these data directly into a bin file (one of the separate...

30 January 2021 9,241 2 View

How to design reverse primer with ambiguous nucleotides?

How to design, reverse primer with ambiguous nucleotides?

03 January 2021 6,762 4 View

Why does the DNA's elution decrease after centrifuging with spin column?

02 January 2021 987 4 View

How to synthesize pyrrolium ionic salt?

I am keenly interested in the synthesis of heteroaromatic ionic salts for use as an organic template. I want to synthesize alkyl pyrrolium chloride or bromide through a simple addition reaction...

30 December 2020 2,778 3 View

How can large volume ( 100 liters or more ) of carbon dots solution be purified and sieved cost-effectively?

Articles describing the use of carbon dots in agriculture have been increasing recently. Again, studies have found that carbon dots size and shape and some other features are effective. Therefore,...

30 December 2020 1,139 3 View

How to Modeling and simulation for launch vehicle?

Modeling and simulation for launch vehicle Title of graduation project for a master's thesis in mechanical engineering, specializing in Control Search assistance required? Thank you

28 December 2020 9,000 1 View

How to calculate average habitat suitability change between 2 different SDM/ENM?

Hi guys, I would love to know how I could go about solving the above question. I currently have 2 different species distribution models, one created with the current climate projection and the...

14 December 2020 864 8 View

What are good M.Sc thesis topic suggestions in construction management (specially BIM & Waste management area)?

My prefered area is in Waste management & BIM , where I have read about using 4D BIM & 5D in waste management , but I have not reached a significant research gap to work on it, so is...

03 December 2020 1,294 2 View

RBC's contamination during DNA extraction ?

Hi there! currently i am working with spin column kit for DNA extraction I've put almost 600 uL of buffy coat. after a lot of washing, the RBC's remained stucking in filter? How could i get rid...

25 October 2020 8,712 4 View

Please, how can I measure the value of the inductance, parasitic series resistance, and the quality factor of this structure using the ADS ?

Dear colleagues. I would like to design the floating active inductor shown in the figure below. Please, how can I measure the value of the inductance, parasitic series resistance, and the quality...

10 October 2020 9,488 1 View

How to compare different concentrations of nanoparticles for characterization from ICP-MS?

I took measurements of different concentrations of 15 nm and 5 nm Au nano particle solutions. I'm trying to determine which concentration I measured gives the best reading overall. I also...

02 March 2021 7,626 1 View

How optimize the Size Exclusion Chromatography?

Hello! I'll do a size exclusion chromatography, but I only have an open column, and I'll perform the peptide extraction from yeast, using buffer lysis (sodium phosphate 50 mM/NaCl 30 mM/DNAse and...

01 March 2021 2,215 2 View

Why are my bands weird in this Agarose gel?

Can someone please give me some possible things that could go wrong? Here is my recipe: 0.5g Agarose 50 mL of TAE 1x 1 uL ethyl bromide. Gel was run at 100V for 1 hour. The buffer used is also TAE.

01 March 2021 9,952 3 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

For modelling epoxy-based matrices (in composites), which model in ABAQUS is the most suitable, Concrete damaged plasticity or Drucker-Prager model?

I am working on developing a micromechanical FE model for predicting kink-band formation in UD composites. To model matrix plasticity, which model, out of Concrete Damaged Plasticity and...

28 February 2021 5,415 1 View

Why there are two peaks while using the mie plot of Silver nanoparticle?

Hi, I am trying to learn the theoretical modelling of silver nanoparticle using the Mie scattering theory. After that, I discovered a software named Mieplot developed by Philip Laven, where it...

25 February 2021 7,493 6 View

How to dissolve cross-linked Amberlite IRC120 H, hydrogen form resin?

Hello all, I have used Amberlite IRC120 H, hydrogen form acidic cation-exchange resin for the ion-exchange of waterglass [sodium silicate solution -- 40% Sodium silicate (mol ratio > 3.2)...

21 February 2021 5,614 3 View

Best protocol for immunogold using araldite resin ?

Hello, We perfom Tokuyasu method (ultrathin cryo sectionning) very often to make immunogold experiments. This time, we need to make a PLT technique with K4M or LR white resin. Our results were...

14 February 2021 4,959 1 View

How to improve the adhesion of epoxy coating on steel substrate? Which factor affects?

I am facing a problem regarding a de-adhesion problem with the coating. A brief description of my methodology is given below. I am using mild or Low Carbon steel as a substrate and I polish the...

14 February 2021 2,167 4 View

Best synthesis method for large scale silver nanoparticle synthesis with high yield?.Best post processing steps after nanoparticle synthesis?

I have chemically synthesized silver nanoparticle to combat microbes on wound site. I have used many methods of synthesis, but I found minimal field of silver NP product.I am getting whitish...

11 February 2021 4,964 13 View