Anyone know of a good progesterone antibody?

I am looking for a good progesterone antibody to quantify levels of progesterone in zebrafish. Applications would be ELISA, and immunohistochemistry.

28 February 2021 5,929 2 View

Is there a suitable way to confine cell attachment area inside a multi-well plate?

Are there any types of cylindrical cell culture inserts that are designed to confine cell seeding area? Say, if I'm using a 12 well plate (3.5 cm^2/well), but only want to seed cells in the middle...

22 February 2021 7,127 4 View

Why am I getting such large heats of dilution in my Isothermal Titration Calorimetry Experiment?

I am trying to measure binding of calcium to an expressed protein we are studying and am getting very large heats of dilution for the calcium solution in my control tests. We prepared a 1 M CaCl2...

07 February 2021 7,532 1 View

I am looking to develop a basic oral microbiome assay. Can anyone advise on culture vessel, conditions and organisms that require minimal maintenance?

I am looking to investigate oral care products with an easy-to-prepare culture of orally derrived microorganisms.

21 January 2021 3,448 1 View

Cause of blisters in ALD layer at the edge of electrode?

I've encountered a defect during processing that I can't figure out, so I'm hoping I might find some ideas here. My mask design is a microelectrode array, with 60 microelectrodes with diameter...

19 January 2021 665 1 View

Difficult to silence gene?

I have been trying to silence a gene of interest but I could not get silencing efficiencies beyond 50% My method of detection is via RT-qPCR and samples were extracted 48hrs post transfection. Are...

09 January 2021 3,404 4 View

What form of data analysis should I use for my pilot study?

I am currently conducting my final year dissertation which is looking at the efficacy of common police lineup practices. However, before I launch my study, I have put out a pilot study which is...

08 January 2021 4,376 4 View

Is it normal to use Tris buffer when testing for bacteriostatic properties of isolated compounds?

Hello, to start off I attempting to test the bacteriostatic properties of certain compounds. I bought a kit that contains some of the equipment to perform this analysis, however, in the included...

02 January 2021 2,338 2 View

Cleaning SGE Micro Channel Device?

Hello all, I have a 3-port SGE microchannel splitter in my Thermo Trace 1310 GC connected to an Isolink 2 combustion interface. My microchannel device is clogged and my flow is significantly...

29 December 2020 7,002 1 View

Weird J-V curve of solar cell?

Recently I am getting low performance (PCE and FF) and weird J-V curves on Pb-Sn-based perovskite solar cells. I have been trying to solve this for a couple of weeks now. I will like any...

19 December 2020 9,336 4 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

No title

02 March 2021 3,060 3 View

How to repeat an operation on an atom selection for multiple times in PyMol?

Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...

02 March 2021 4,569 4 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View