the protocol i am using for RNA extraction states i should spin at 12000 rpm for 1 min at some steps, however, the centrifugation device i am using reaches that speed after 1 min of hitting the start button. should i add an additional minute of spinning to what the protocol states ?
Bhairavi Vajaria
Yes... after the speed of 12000 rpm is attained, spin for 1 minute. So in your case it will be 2 minutes.
1 votes
1 thanks
Saeed Ayaz Khan
If spinning are for 2 minutes then 1st minute spinning for what is not against the procedure.?
0 votes
0 thanks
- Badges
- Science topic
- Similar topics
- Analytical Chemistry
- Extraction
More Ahmed Abdelhamid's questions See All
Similar questions and discussions