Hello people,
I have an assembly, where i have performed a steady stress analysis.
My goal is to remove material at low stress areas in order to reduce the overall weight of the assembly.
I would like to ask you if there is a specific study at SolidWorks to reduce weight with the way i described above.
I would like a reduced material result, just like the picture i attached.
Thank you
I couldn't understand how you could reduce the overall weight by adding material???
Sreeraj P R i meant it like a redistribution of material but yeah it was a fault reference.
John Louloudakis , topology optimization will do what you're asking. Solidworks has a built in capability that allows you to control several design parameters and optimization goals. https://www.solidworks.com/media/topology-optimization
- Badges
- Science topic
- Similar topics
- Biological Science
- Physiology
- Physiological Processes
- Stress