4 Questions 3 Answers 0 Followers
Questions related from John Louloudakis
Hello there, I'm trying to start a routing path through Solidworks routing add-in. I want start my pipe routing from a some holes that i have on my sketch just like the picture shows. At the 1st...
29 July 2021 6,836 2 View
Hello people, I have an assembly, where i have performed a steady stress analysis. My goal is to remove material at low stress areas in order to reduce the overall weight of the assembly. I would...
18 November 2020 7,836 3 View
Hello , Im doing a structural analysis on a geometry at ansys mechanical apdl. After the analysis , i want to print the overall volume of my geometry in order to calculate the total mass. Im...
10 June 2020 3,608 1 View
I have made this half-wing through Solidworks and imported to Ansys ADPL. I want to do a Structural Analysis , so i have put some pressures and some displacements - supports (all DOF's value 0) in...
04 December 2019 3,226 3 View