I am tring to si,ulate FInfet in sdevice . But when I putting fine meshing i am getting exit due to failure after some iteration.So, what should I do to get the output. I am attaching the .out file also.
thank you for reply.
At first I am trying to simulate input chara, then I got iteration converging problem. After that I increase the iteration number now it is ok. But for output chara I am facing converging problem. At first I did not use recombination model, now using recombination model, but nothing has been changed.
I am also guessing, but I think meshing devices would solve this problem.
"CNormPrint" in math section would help to solve at which mesh was failed to converge. After then, you make mesh at that point much dense.
I hope you can fix the problem.
Best wishes,
Jun
- Badges
- Science topic
- Similar topics
- Filing