Sandip Ghose

5 Questions 5 Answers 0 Followers

Questions related from Sandip Ghose

In SRAM design is it possible that the static noise margin is greater than write margin?

27 March 2016 3,354 3 View

What should be the meshing for 32 nm finfet in AC analysis?

I am designing a 32 nm fineft, in Dc it is working fine but when I try in AC analysis, I always get "Exit due to failure " error message. I think it is a meshing problem. But what would be the...

29 February 2016 3,375 0 View

Actually I am trying to design complementary FinFET with mixed mode tool. In Sentaurus device how should I define load capacitor ?

here is an example which i follow. But i got a error message with "unknown device capacitor_pset"

12 February 2016 2,384 2 View

Any advice on the Sentaurus s device showing " Floating point exception caught"?

As I increase the doping concentration , I am getting " Floating point exception caught" , What should be the solution for this.

02 December 2015 7,758 2 View

Sentaurus sdevice shows "exit due to failure", what should I do?

I am tring to si,ulate FInfet in sdevice . But when I putting fine meshing i am getting exit due to failure after some iteration.So, what should I do to get the output. I am attaching the .out...

23 November 2015 6,278 2 View