Does anyone used the data logger other than DAQ(LabVIEW) for welding temperature measurement?
If yes
Can we get required data by using the data logger or do we need to use the DAQ itself?
(Apart from the cost comparison)
Anoop,
I've used a variety of logging devices over the decades.
What exactly are you wanting to measure?
Article Effect of welding sequence on temperature distribution, dist...
I used the Agilent 34970A data acquisition/switch unit (see Fig. 2), together with the BenchLink Data Logger software, to record the temperature histories on selected points.
Hello. You can use any module that you have.... Data logging and connection to the module are just a few lines of programming in Labview.
I have utilized NI 9211 Temperature data acquisition card and k-type thermocouple for in-situ temperature measurement. Also, you can use Arduino-based temperature measurement sensors (calibrated).
Refer to the following article for more details:
Article A multi-tier layer-wise thermal management study for long-sc...
- Badges
- Science topic
- Similar topics
- Engineering
- Materials Engineering
- Powders