Can we realtime stream data from Vicon Nexus (Streaming Vicon Blue Trident IMU data) to LabView?

05 July 2024 0 1K Report

We are using Vicon Blue trident IMUs for motion analysis. Nexus is used to stream data from IMUs currently, which are giving accelerometer, gyro, magnetometer and global angles. These data are streamed to Nexus using a Bluetooth dongle connected to host PC. Is there a way I can Stream these data in LAbView real-time by interfacing LabView to Nexus? Does this need any additional hardware support?

Badges
Science topic

More Shifin As's questions See All

How to implement monte carlo method to compute state value in matlab ?

assume there are 80 states each with a possibility of 2 actions. we have a predefined reward function. The problem is about research allocation.

30 October 2020 9,930 3 View

I am trying to use Modified cam clay as soil model in the simulation of an excavation problem in FLAC. I am getting an error. Can someone help?

The error says "Current value of tangent bulk modulus is larger than maximum input value". Input parameters were taken from a journal. When I try changing the bulk modulus, the error message is...

08 October 2019 5,267 3 View

What is the different between model, architecture, framework, and protocol in computer science?

I know this question is clear but I want to know the difference between these facts especially in computer science?

31 May 2019 5,710 2 View

Why the crack propagate in that direction (to the left hole)?

Left side of the specimen is applied with fixed support and load is applied downward on the right hole. I need an explanation why the crack propagate to left hole. What i have in mind is since...

18 February 2019 2,159 1 View

Why so called dark matter is outside the galaxy?

The so called dark matter is pictured out side the galaxy. What is the reason? why cant it be a part of the galaxy itself ?

03 September 2018 155 4 View

Can non-motile bacteria perform chemotaxis?

Most model for chemotaxis are flagellated bacteria. Im just wondering how this non-motile organisms adapt to starvation or repellent. If you can provide me some journal article that would be...

02 March 2018 9,880 3 View

Why high ROS signal in flowcytometry and fluorescence microscope?

Hello I want to investigate the effect of high temperature on ROS production in yeast. I have yeast cells which grow at 30 degree as a control and experiment cells grown at high temperature.I used...

21 April 2016 8,392 5 View

If two proteins run in sds page with different molecular weights, if both show bands with same intensity, does it mean they have same concentration?

If two proteins run in sds page with different molecular weights(having difference of 60 KDa),if both shows bands with same intensity,does it mean they have same concentration?

03 November 2015 9,304 3 View

Serum starvation in cell line treatment?

How long after seeding of cell line, should I do serum starvation or serum 4%? 24 h or less? How long should it last (before treatment) or serum 4%? 24 h or less? i i want to do serum starvation...

05 December 2014 8,834 3 View

In SDS PAGE, actin crosslinking doesn't show any significant increase in mass comparing actin bindings - any thoughts?

Can anyone help me to explain while running my protein samples in SDS PAGE, Actin crosslinking doesn't make any significant increase in molecular mass comparing actin binding protein samples.

29 August 2014 9,634 3 View

Anyone give me assistance with analysing Gait Data?

I currently have collected Gyroscope/Accelerometer data (X/Y/Z) for my dissertation, but not very knowledgeable on how to process my data and apply Machine Learning? Can anybody help?!

24 February 2021 9,610 3 View

What low-cut filter (high Pass frequency) to be used for response spectrum (Tripartite plots) ?

What low-cut filter (high Pass frequency) to be used for the response spectrum (Tripartite plots)? I am currently working on differentiating between hard/soft site responses in Indo-Gangetic...

21 February 2021 9,273 2 View

Algorithms to filter corrective max and min from a set of data?

I've got this 5 year Direct Normal Irradiance data I downloaded from https://re.jrc.ec.europa.eu/. I ordered this by year and by every 24 hours because I need the DNI curve by max in summer, min...

17 February 2021 2,777 5 View

How to improve results of system identification procedure?

Hello, I'm performing system identification of the lateral closed-loop dynamics of a quadrotor. My model receives a setpoint and should return position and acceleration. I've proposed a second...

07 February 2021 9,791 2 View

Comparing Uniaxial accelerometer sensors activity counts with Triaxial accelerometer (IMU)'s activity counts?

Hi I have to compare the uniaxial sensor(wearable) data with Triaxial sensor data(IMU). The uniaxial sensor output has a single column of activity counts whereas Triaxial sensor(IMU) has three...

05 February 2021 3,999 1 View

Marker Set for 3D Motion Tracking of Upper Arm during Pointing Task?

Does anyone have recommendations of a marker set for 3D motion tracking of the upper arm during a pointing task? Most studies I have come across have focused on reaching. I plan to use Vicon Nexus...

12 January 2021 3,198 1 View

How to get the natural frequencies and mode shapes using several acceleration data?

I am using FDD (code I used - https://uk.mathworks.com/matlabcentral/fileexchange/50988-frequency-domain-decomposition-fdd) to extract the natural frequencies and mode shapes using the...

03 January 2021 4,038 2 View

Does anyone know where I could find a LabView driver for a Zahner Xpot Potentiostat?

I am using a Zahner XPOT potentiostat and I want to control the instrument by a LabView driver, as the original software of the potentiostat lacks many functionalities. I already searched in the...

09 December 2020 5,537 2 View

Which automatic data processing for angle detection in Plugin Gait (VICON) do you use?

I would like to analyze gait cycles (running) - is there a smart way for cycle detection and calculation of the angles for each joint (average/maximum) for a certain amount of cycles - without...

07 December 2020 2,586 2 View

Why do I not get any values from LSM6DS3 sensor ?

I have a LSM6DS3 sensor wired to a Wemos d1 mini microcontroller and am using Arduino code to get acceleration and gyroscope data from the sensor to display to the serial monitor. I am getting...

17 November 2020 5,244 3 View