I am modelling a foundation connection to a wind barrier. The connection is 4 prestressed bolts with an anchorage plate in the bottom, it is all cealed in a clump of concrete. When I change the contact between the bolt and the footplate to frictionless, I am getting the following error "An internal solution magnitude limit was exceeded. Please check your Environment for inappropriate load values or insufficient supports.".
I tried going through all the contacts, but I can't seem to find any contacts that are not connected properly.
I can run the model with the conctact between the bolt and the footplate as bonded. But that is not how the model should run.
Thank you
There is not any info about assigned boundary condition.... I suggest that check contact between bodies and type of contact, and refine mesh size in sensitive zone.
There is not any info about assigned boundary condition.... I suggest that check contact between bodies and type of contact, and refine mesh size in sensitive zone.
- Badges
- Science topic