Is there any tutorial for comsol general projections?

Hi, im trying to make a projection in a 3d comsol model. I have a non uniforme chanel and my intention is to get the average tempreture in the y-z cross section and se the average tempreture...

02 March 2021 4,624 4 View

Where can I find public datasets with Covid-19 patient information?

Hi, I'm looking for public datasets that have CT, X-ray information, or medical records for patients with Covid-19. Does anyone have suggestions?

28 February 2021 4,760 3 View

How to locate and collect the pineal gland in the amphibian brain?

Our team has been trying to locate and collect the pineal gland in the American bullfrog's brain (Lithobates catesbeianus) for some time now. However, we don't have a standardized protocol for...

18 February 2021 3,453 4 View

Can comsol probes be used for stationary studies?

I'm trying to plot while solving comsol probes vs iterations, but the only option i see for x axis is row index from the probes table. And all i can get is a graph with just a point with the value...

22 October 2020 4,618 1 View

RTD Step analysis with matlab?

Hello to all my dear colleagues. I need to get my E(T) curve for my reactor. I already have the measures but I ignore how to procede with the data analysis. I have got Matlab but i am not sure if...

21 June 2020 2,675 5 View

Help about chemical sludge characterization?

Hello. I did run some coagulation / flocculation experiments[FS1] and I have been requested to characterize the sludge. I am ignorant on how to so. I was only requested to do SEM, XRD and Zata...

16 June 2020 8,715 7 View

Split-Hopkinson pressure bar - minimum strain rate?

Does anyone know wich is the minimum strain rate that is possible to get in a Split-Hopkinson test?

20 February 2020 1,835 2 View

3D unstructured meshing in FEFLOW?

Hello, I'm using the latest version of FEFLOW (7.3) and I need to generate a fully 3D unstructured mesh. I already imported a .stl solid shell, wich has no problems at all (i.e. it's a very clean...

31 January 2020 1,365 2 View

In solar heterogeneous photocatalysis, is solar geometry relevant?

My project is supposed to considered solar irradiation as an important variable for heterogeneous photocatalysis. I haven't found any study that considers solar geometry as a variable of study in...

30 January 2020 744 3 View

Massed or interspersed trial in DTT (aba program)?

I would like to hear from fellow behavior analysts on massed trials and interspersed trials. Maybe I did not understand the concept well, so I will post here what I understand by each type of...

26 November 2019 8,433 1 View

Why does blocking with my immunogenic peptide cause nuclear fluorescence in ICC?

Hi all, I am validating a polyclonal antibody raised against human ANT4, through WB and ICC. In most of my controls, the antibody shows very little off-target binding, but when I pre-incubate the...

03 March 2021 5,999 3 View

Does anyone have a recommendation for yeast reporter gene plasmid/protocol?

Hi, could anyone recommend a plasmid and/or protocol for reporter gene assay in S. cerevisiae? I want to assess the effect of growth conditions on a transcription factor, so I want to clone it`s...

01 March 2021 210 1 View

RIA. How to measure?

When you use RIA, with a control the unknown sample with antibodies, you bare in mind the binding sites of the antibodies. However you still need to measure labelled antigen (radioactive) and not...

28 February 2021 2,133 3 View

No title

23 February 2021 4,014 3 View

How to reduce static electricity of powder after lyophilization?

I am working on synthesizing and then purifying peptides using the SPPS system. After purification of the peptide, the peptide powder is obtained using a freeze dryer. When measuring the powder,...

22 February 2021 10,099 5 View

Can we remove the fmoc group after peptide cleavage?

I have synthesized the peptide using Fmoc based solid phase peptide synthesis. Also I have cleaved the peptide from the resin and lyophilized it, but later realized that, I forgot to deprotect the...

21 February 2021 4,537 3 View

How T cells recognise non-peptide antigens?

This might sound very basic question, but please share with me an explanation of how the T cell is activated when the antigen is not a peptide? What happens? And what are the molecules involved in...

21 February 2021 564 3 View

What is the best temperature to coat an ELISA plate?

Hello, I want to control the temperature of my ELISA plate during incubations to get consistent results. In general, what is the best temperature to coat the plate with antibody? I have been...

16 February 2021 2,377 7 View

How can I use Permanova to analyze individual variation with RNA seq transcripts and multiway Anova design?

I have a dataset with 96 individuals and 1496 transcripts of interest. I have analyzed the experiment by multiway ANOVA in the Permanova platform of Primer-E. I am satisfied that I have figured...

13 February 2021 7,217 4 View

Can Immunogenic BNT162b vaccines protect HUMANS from SARS-CoV-2?

"A safe and effective vaccine against COVID-19 is urgently needed in quantities sufficient to immunise large populations. We report the preclinical development of two BNT162b vaccine candidates,...

11 February 2021 6,628 9 View