Dear all,
I want to try filipin staining at the first time by using filipin sigma (F-9765). please give me suggestion and what kind troubleshooting for filipin staining.
best regards,
Dewi Yuliana
How do you do variogram analysis if you only have 1 well data?
01 February 2024 2,912 3 View
Hello Im Yuliana Jiménez Gaona, and I want to shared that the user Yuliana Gaona is taking my research and already associated with her profile ResearchGate...
23 January 2024 1,875 3 View
Hello, is anyone doing cell culture for shrimp hemocytes? I have a problem with cell sorting; I cannot get the cell sorted out. I hypothesize that I used the L15 medium and did not adjust the...
13 December 2023 6,185 1 View
Hi, I'm working on uncertainty analysis using petrel. In the variables tab, there are base value, minimum and maximum. How to determine base value, minimum and maximum?
23 November 2023 8,259 3 View
Hi, everyone, i did BET analysis for my material and i am not really sure that all the adsorption desorption isotherm graphs showed open loop hysteresis. What is the reason for the open loop...
15 April 2023 2,449 2 View
state of markov switching autoregressive
15 August 2022 2,773 0 View
Recently I did RNA seq on mycobacterium. I got the TPM data from one of our colleagues in the Bioinformatics department because they helped us to analyze the raw data. Then, I'm interested in...
15 April 2022 1,903 5 View
Negative peaks like the one in the image are always present when samples (and mobile phase as blank) are injected into columns with cross-linked polystyrene-divinylbenzene matrix. RI is used as a...
16 November 2021 3,474 4 View
How much can a genetically modified bacterial strain approximate cost in which a gene has been inactivated in the wild strain and a plasmid with two genes of interest has been inserted?
03 September 2021 4,891 2 View
Why we must do the research about gaining antibiotic compound from endophytic microbe? Isn't enough getting antibiotic from plants? Because we just need a little dried powder from plant to get...
12 April 2021 3,074 3 View
I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...
09 August 2024 9,621 0 View
Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...
09 August 2024 2,824 3 View
I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...
07 August 2024 7,535 4 View
I am staining some brain sections stored in cryoprotectant that express a Histone H2B- GFP fusion protein that were generated ~10 years ago. I know I need to enhance signal with an anti-GFP...
07 August 2024 5,338 2 View
Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...
07 August 2024 8,106 4 View
Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...
06 August 2024 641 2 View
To compare positive and negative cell populations in flow cytometry, should I compare unstained cells with antibody stained cells? Or with the isotype control? Most papers show comparison with...
06 August 2024 6,728 6 View
Hi all, I was just wondering if anyone has experience with multiplexing a mouse monoclonal primary and a rat primary. I'm trying to multiplex by incubating them in the same well but was told by a...
06 August 2024 9,710 1 View
I have tried several times to isolate lymphocytes from mouse spleen, but all attempts have been unsuccessful. I tried most available protocols. I used different dissociation media (HBSS with Ca...
04 August 2024 9,913 7 View
I have protein-membrane simulations (PDB, PSF, DCD) and have noticed that water molecules near the protein are not visible in the simulations. How can I fix this issue? Is there a way to place the...
04 August 2024 1,200 2 View