Hi,
I am looking for a detailed protocol where I can measure both mitochondrial and cytosolic calcium dynamics using live cell imaging? The buffer conditions and the optimal ionophore concentration to be used?
thanks
devi
Hi, I wanted to do bisulfite treatment on tRNA (length 72bp) and design taqman probes for methylation specific PCR. Have anyone done this before and could you please let me know the things which i...
01 February 2016 3,077 0 View
I need a very good protocol for competition binding assay. I have a complex and a third protein. I expect the third protein to dissociate the complex by binding with one partner of the complex....
10 November 2014 5,936 3 View
I am trying to purify two proteins. Protein 1, is around 16kd, sequence verified, expression verified via western blotting. problem is induction. it is not induced. i tried various concentrations...
09 October 2014 2,531 10 View
I am trying to subclone gene of my interest along with tag from pcdna3.1 to pET28b vector. As the insert has its own ATG, gene of interest and fusion tag in frame, I want to cut the whole lot and...
08 September 2014 551 6 View
See above.
05 June 2014 3,508 8 View
Hello! I want to quantify by ELISA the secreted (from platelets poor plasma) and the non-secreted (from platelet lysate) PF4 before and after TRAP stimulation. I will use the ELISA from R&D...
03 March 2021 1,499 2 View
Hello, If i am doing a buffer exchange for an antibody of 1mg/mL, does the elution lose protein in the process of buffer exchange? For example, if i flow through 500 uL of 1mg/mL sample, and...
03 March 2021 6,299 3 View
Hello! I'll do a size exclusion chromatography, but I only have an open column, and I'll perform the peptide extraction from yeast, using buffer lysis (sodium phosphate 50 mM/NaCl 30 mM/DNAse and...
01 March 2021 2,215 2 View
Can someone please give me some possible things that could go wrong? Here is my recipe: 0.5g Agarose 50 mL of TAE 1x 1 uL ethyl bromide. Gel was run at 100V for 1 hour. The buffer used is also TAE.
01 March 2021 9,952 3 View
I'm looking at the aggregation of my protein sample using DLS. Unfortunately, my buffer (20mM HEPES) also results in a set of peaks. These are at approximately 1 and 1000 d.nm. The lowest peak...
01 March 2021 9,015 2 View
I need to extract protein from fermented carbon sources for Bradford assay. Most researchers experiencing insolubility of pellet in resuspension buffer. Please assist me to select most suitable...
26 February 2021 7,129 3 View
Hi all, I have been doing research on biotagged LDB1 proteins in Mel cells. I purify the proteins using M280 streptavidin beads. The yield is very low so I've been trying to optimize it by...
24 February 2021 5,749 3 View
Hi everyone! I try to detect VDR protein (~48 kDa) using Western Blot. After SDS-PAGE using 10% MP TGX Stain-Free Gel from BioRad I transferred the protein onto an metOH activated PVDF membrane...
23 February 2021 6,266 3 View
Hello! I am interested in determining whether a poly-unsaturated fatty acid I have engineered E. coli to produce is being incorporated into the membrane of the cells or if it is simply a free...
21 February 2021 7,447 2 View
Hello everyone I would like to improve the buffer capacity of seawater (pH ~8) in order to dissolve as much CO2 as possible without dropping the pH below 7.5 (a range between 7 - 7.5 is...
17 February 2021 2,797 2 View