Dear All,
I am actively looking for private labs in india which can do mass spectrometry analysis of serum and plasma sample (human) for proteomics based biomarker studies. Any suggestions you have would be greatly appreciated.
Best Regards
Baskar C
By experimental study i need to optimize and to find out the binding energy of interactions. so which level and what input i need to give.
29 April 2024 5,391 6 View
I prepared carbon materials from biomass waste. I studied preparation of carbon materials from biomass using a catalyst and without a catalyst in pyrolysis process. Catalytic pyrolysis leads to...
24 September 2023 6,878 3 View
Hello researchers, I have been modelling the cyclic behavior of bracings using ABAQUS. when I take the hysteresis loop once the model has run I get the graph with straight lines as shown in the...
22 January 2023 1,237 3 View
I am trying to quantify glycerol (CH2OH-CHOH-CH2OH; MW - 92.1 g/gmol), 3-Hydroxypropionic acid (3-HP; CH2OH-CH2-COOH; 90.08 g/gmol) and 2,4-Dihydroxybutyric acid (2,4-DHB; CH2OH-CH2-CHOH-COOH;...
29 July 2021 7,445 1 View
Dear Researchers, I am working on flexible Na ion battery using gel polymer-based electrolytes. I tried with various PVA-based gel polymer electrolytes. But the cyclic voltammetry of PVA/Sodium...
20 February 2020 8,008 4 View
Dear all, I am working on an uncharacterised protein. The function of this protein in mammalian cell is yet to be discovered. I over-expressed the protein did interaction and co-localization...
01 August 2018 9,280 2 View
I want to design a engine with both 4 stroke and 2 stroke for better torque and lower fuel consumption. I want to know if we design a engine with both 2 stroke and 4 stroke, what would be...
09 April 2017 4,955 9 View
I have the std curves alizarin red solution using CTCI also have the total protein cantent values to which Ca conc. has to be normalized.eg: The concentration of ARS in mg/ml = 3.8766
08 August 2016 6,679 2 View
I am currently using a broadband light source (300-1100 nm spectrum) and my dispersion at a few feet is too large for me to receive any feedback. I understand that I cannot increase brightness but...
31 March 2016 314 3 View
Dear All, I am planning to analyze climate variability of an area of 1 lakh sq km. Which model is suitable. Need your kind suggestions?
26 February 2016 3,035 2 View
Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...
11 August 2024 8,141 3 View
Hello experts, Does anyone know any free software about retention index prediction ?
08 August 2024 7,403 2 View
I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...
08 August 2024 8,329 0 View
I attempted to make a privately uploaded text public but a window appeared that said an error occurred. There was no explanation provided as to why there was an error or what might be done to...
05 August 2024 8,025 7 View
I am trying to adapt adherent CHO-K1 cells in F12K+10%FBS to suspension culture in only F12K, but in vain. I have followed Mirus bio as well as Thermo protocols, please suggest any alternative....
31 July 2024 3,756 0 View
I want to perform a CRISPRa/i library screening for candidate regulatory factors that affect pathogenic Th17 differentiation in PBMC. But I am wondering how to define the size of gene library, so...
31 July 2024 2,150 0 View
EDX analisys
31 July 2024 5,947 2 View
I am working on algal extract to which gas chromatography (Not GC-MS) spectrum I want to discover. My question is can we identify specific compounds using retention time if I compared the RT with...
29 July 2024 8,034 4 View
We have encountered an issue with the serum of mice being hemolyzed after the process of centrifugation. Could you please provide guidance to prevent hemolysis ?
29 July 2024 8,402 4 View
I have been running a MAGeCK test command on the terminal for a CRISPR screen to rank sgRNAs and genes based on the read count tables. However, I get only the plot of the top-ranked genes...
28 July 2024 9,811 1 View