MnFe2O4 Fenton like catalyst while use in bicarbonate system ,the trend of absorbance increasing with the time instead of decrease. why it is happen?

25 December 2024 0 6K Report

When i use this catalyst at pH 3 and 11 it showed better performance. When i use it in the KHCO3 reaction solution instead DI water the trend of absorbance was inverse. please guide me what could be the phenomenon behind this. looking forward for the suggestions Thanks in advance.

Badges
Science topic

Similar topics
Chemistry
Chemicals
Solvents

More Sajia Ameen's questions See All

Anyone help me about any study about effective exercise on venous blood gases ?

Research or review

02 December 2023 7,108 3 View

Is sports exercise affects the balance of arterial blood gases ??

16 September 2023 1,130 1 View

Best software for 3d face model construction?

Hi dear I need reliable software for making 3d models of the face from multiple images for research purposes.

12 September 2023 9,265 2 View

Please teachers and researchers help me by answer this question’s The question is the state of researches in Kurdistan region in now?

Answers should include the following points, strengths point of research in Kurdistan, weaknesses point, opportunities, and potential challenges of research.

04 August 2023 4,435 0 View

I want to do an association between obesity and driving in a case-control study. If my case was drivers, what should the control be?

I want to do an association between obesity and driving in a case-control study. If my case was drivers, what should the control be? Should it also be a driver or other job?

22 July 2023 8,225 3 View

Hi, I have if you have results with µg/mL from a calibration curve how do i change my results to mg/ml ??

note: I used spectrophotometry in my work

17 March 2023 1,996 4 View

Why do we need to use different Audio Encryption Tests to measure the quality of encryption?

Hello colleagues What are the differences and what is the indication of each audio encryption test such as SNR, Spectral Segment SNR, Peak Signal to Noise Ratio, Linear Predictive Code Distance,...

21 January 2023 4,577 1 View

Is there any Revit plugin to calculate thermal insulation of the building parts?

The question is clear... either to the building as a whole, or as parts.

24 December 2022 2,177 2 View

Socioeconomic status questionnaire?

Hi, i am looking for a simple questionnaire to investigate the Socioeconomic status of patients, and ideally to categorize them into low/middle/high. any ideas? thanks

26 November 2022 3,168 4 View

Can some one suggestion a free journal or journals that can accept manuscripts on solid waste classification and Anions and Cations in Leachate ?

The two manuscripts are written from my Ph.D. research work and my studies center on Solid Waste Management and the leaching effect of Leachate on soil, sediment, surface, and groundwater within...

09 July 2022 6,634 0 View

Aspen Plus Simulation?

Greetings When one is to perform Simulation or modelling of Pyrolysis of Biomass Waste materials using Aspen Plus software, and one has both the macromolecules breakdown (Cellulose, Lignin and...

06 August 2024 5,023 1 View

Need heterogeneous catalysts calcined before reduction?

Metal-containing heterogeneous catalysts often need to be calcined before reduction, so what are some examples of catalysts that perform better without calcination? What is the reason and how many...

05 August 2024 909 2 View

I have calcined my catalysts without flowing air from the compressed air cylinder will there be any problem with my reaction if i use that catalysts?

FYI Catalyst is MFI zeolite Si/Al = 140,25.40.11.5,15 I am using this catalyst to study methanol to DME conversion

25 July 2024 2,486 2 View

Alternative binders other than Nafion solution?

Hi Everyone, I plan to deposit a catalyst (TS-1@Co-PDA, in the core: TS-1 zeolite with a shell of Polydopamine designed with Cobalt) on a rotating ring-disk electrode (RRDE) to evaluate the...

29 June 2024 8,203 3 View

Is it possible for the soil pH to be around 8, but with negligible amounts of carbonates, bicarbonates and exchangeable sodium?

Can this pH of 8 be due to the presence of other substances? Or do I have an error somewhere in the analysis? Thank you!

26 June 2024 9,093 4 View

Why reaction order is changing with temperature? Is it a non elementary reaction?

I am performing catalytic metal supported benzyl alcohol reaction kinetics in presence of potassium carbonate base. Every time order change observed at lower catalyst conc. It showing zero order...

20 June 2024 7,100 2 View

How to perform the DFT calculation on the mechanism of Photocatalytic CO2 reduction with water?

Dear Researchers, I hope this email finds you well. I am currently working on research involving DFT calculations to study the mechanism of CO2 reduction using a catalyst with water as the...

14 June 2024 4,612 4 View

What are the approximate quantities of Ni/Al₂O₃ and Cu/ZnO/Al₂O₃ catalysts required to produce 2095 tons of methanol per day?

A methanol production process combines tri-reforming of methane (TRM) with water electrolysis to utilize CO₂. The TRM reactor uses a Ni/Al₂O₃ catalyst, and the methanol synthesis reactor uses a...

10 June 2024 2,105 1 View

Do gases emerge from catalytic oxidation in the presence of zeolite as a catalyst, and what are the gases, if any?

30 May 2024 7,061 1 View

Why I should use UDF for modelling hetrogeneous Reaction ?

Hi Everyone, I am using a UDF file that contains coke oxidation of spent catalyst. I was wondering if there is any way to use the built in Function in Ansys instead. Furthermore, coke oxidation...

23 May 2024 4,240 0 View