How can I measure MMP-1 protein activity or protein level from liver tissue?

Instead of checking only the mRNA level, I want to check the active protein level of MMP-1 in Liver tissue from mice. How can I do that?

03 March 2021 1,763 2 View

Binary Logistic Generalized Linear Mixed model in SPSS. Is it doable?

I want to analyses the proportion of swimming sperm of three species of fish in two salinities. To analyse the proportion of swimming sperm in a Generalized Linear Model, I would use a Binary...

03 March 2021 2,297 3 View

Looking for Materials with high thermal expansion coefficient and high temperature resistance?

03 March 2021 8,272 1 View

Guidelines for survey (question type) analysis?

Hi. Please tell me what guidelines should i need to follow for questionaries' type research work in India. It is not hospital based work, we are conduction basic institutional based qualitative...

03 March 2021 2,037 3 View

What are the values needed for gabor filter's parameter for cifar10 data?

Hi, I implemented a code to gabor filter cifar10 data but the images after being filtered and stacked are not clear like the original images. I think the problem is in the way I am using the...

03 March 2021 6,317 1 View

Can we block unwanted images during the x-ray prediction?

i am try to classify the x-ray images. During classification , can i block unwanted images (except x-ray image).

03 March 2021 7,100 1 View

No title

03 March 2021 5,360 2 View

What techniques can I use to determine the miscibility of polymer blends?

The term miscibility refers to the single-phase state in thermodynamics. I do not mean the compatibility of different components. To determine the miscibility I know several techniques such as...

03 March 2021 4,107 4 View

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

The procedure compute?

02 March 2021 5,204 3 View

How to remove fatty material from plant extract?

The resultant solid was partitioned three times with 250 ml of petroleum ether (40-60/c) to remove any fatty material and evaporated to dryness.

28 February 2021 9,464 2 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

How to improve the adhesion between germanium and silicon monoxide thin film layers using EBEAM evaporation?

I want to deposit multilayer coating of germanium and silicon monoxide on silicon wafer using ebeam evaporation?

21 February 2021 2,141 3 View

How to improve the buffer capacity of sea water?

Hello everyone I would like to improve the buffer capacity of seawater (pH ~8) in order to dissolve as much CO2 as possible without dropping the pH below 7.5 (a range between 7 - 7.5 is...

17 February 2021 2,797 2 View

PV system design. 3d modelling and Analysis?

I have been looking for a good cost-effective tool for 3D modelling a glass-glass solar module system. I was initially considering Skelion as a tool but it does not look very promising, a bit...

13 February 2021 8,126 1 View

How to determine measurement uncertainty of a mass balance?

Hi everyone, I work at a factory plant where they use a mass balance. The problem is that there is an huge difference between the input and output of one element. There are several people working...

10 February 2021 5,764 3 View

A film coverage that allows for transmittance of wavelengths on the infrared scale?

I've landed on needing some type of highly optically transparent film or cover material that prevents evaporation of culture media; I am not sure which subfield of materials science would be able...

08 February 2021 5,760 1 View

I have a problem with sensible heat flux (H) iteration process in Sebal model?

In each iteration, I get the same value of H for different values of aerodynamic resistance and the temperature difference between two heights. Do the results make sense? Is it necessary to adjust...

07 February 2021 8,953 2 View

What are the advantages and limitations of online teaching mode of HEIs; and how we can make a balance between them?

With the increase in use of online modalities during the current situation, it is necessary to assess the advantages and limitations with regards to teaching and learning from various...

04 February 2021 4,558 8 View

Data balancing before test/train split or only training data balancing. which is correct?

While reviewing technical articles, I encounter some papers where authors have used data balancing before splitting test and train (on full data), and some only balanced training data and let the...

04 February 2021 1,446 0 View