I am looking for a way to carry a deformed geometry from a simulation to another one without the strains and stresses.
I know that there is a keyword for springback with which I can do prestressed simulation but I need to find a way to do this while deleting all the emerged strains (plastic as well) and stresses.
What options do I have?
Thank you very much if you can help!
Javad Mehrmashhadi
Popular answer
In LS-PrePost, do the following:
- 1. Using the animation controls, display the state to output
- 2. From menu, go to FEM/Pst/Output (alternatively go to the Page1 Output Interface)
- 3. Select a format (Keyword, Movie BYU, Nastran, Dynain, InitDisp, STL)
- 4. Select Active Parts Only or Entire Model
- 5. Select desired data (Element, Nodal Coordinates, etc...)
- 6. Click Current to select the state
- 7. Click Write (pops up file selection dialog)
- 8. Enter output file name and click OK
3 votes
1 thanks
Javad Mehrmashhadi
In LS-PrePost, do the following:
- 1. Using the animation controls, display the state to output
- 2. From menu, go to FEM/Pst/Output (alternatively go to the Page1 Output Interface)
- 3. Select a format (Keyword, Movie BYU, Nastran, Dynain, InitDisp, STL)
- 4. Select Active Parts Only or Entire Model
- 5. Select desired data (Element, Nodal Coordinates, etc...)
- 6. Click Current to select the state
- 7. Click Write (pops up file selection dialog)
- 8. Enter output file name and click OK
3 votes
2 thanks
- Badges
- Science topic
- Similar topics
- Biological Science
- Physiology
- Physiological Processes
- Stress
More Péter Király's questions See All
Similar questions and discussions