Hi everyone,
I need to isolate mouse neutrophils from Bone marrow using percoll.
If you have experiences with it, please share the protocol with me.
Or do you use other medthod, please also share with me.
Thank you so much.
Hello Trang Anh Thi Tran
You could use the protocol attached below.
https://www.tau.ac.il/~arielm/Ariel_Munitz,_PhD/Protocols_files/Murine_BMN_Prep.pdf
It may be helpful.
Best.
I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...
10 August 2024 4,005 2 View
I have been working on Red blood cell-derived extracellular vesicles as Antisense Oligonucleotide (ASO) carriers. We normally run agarose gel to quantify the loading efficiency. I used naked ASO...
06 August 2024 3,130 2 View
Hi all, Do you know how to plot this figure? I found many of them in Nature journals but have not figured out how to make them. Which software/tool do you suggest? Thank you very much.
15 July 2024 8,384 2 View
Hello everyone, I am new to LabVIEW, right now we need to control the movement of an ethernet-based stage drive. We got the sample code from a collaborator but their instrument is USB-based, so we...
11 July 2024 5,385 2 View
I utilized a Bayesian state space model to analyze the data. The 95% confidence interval, which ranges from 0.0 to 1.2, prompts the question: Is the regression coefficient significantly different...
01 July 2024 9,575 2 View
How to calculate Module Young from compressive strength and strain curve
29 June 2024 817 3 View
The software used for genebank to store and manage information, it could be free or licence (friendly to use)
24 June 2024 285 0 View
I prepare Mg doped Hydroxyapatite by wet preipitation but (Ca + Mg)/P ratio is higher than 1,82. CaO peak cannot be detected in XRD spectrum
23 June 2024 8,970 19 View
I've been fabricating traction force microscopy devices in glass bottom dishes, using a method that first spins a 100 micron PDMS layer, then a ~1 micron PDMS + fluorescent beads mixture layer....
09 June 2024 652 2 View
I used filament tracing of Imaris to reconstruct dendritic spine and I got the statistic result of dendritic spine density. I wanted to count dendritic spine density in secondary and tertiary...
06 May 2024 8,675 0 View
Hello, I am currently having problems with RNA extraction. I am using mouse liver (C57BL6J), and I have extracted RNA from mouse liver before. Before this experiment, my final RNA pellets were...
11 August 2024 7,082 3 View
Can anyone share any reference that gives mouse specific CD3 antibody sequence. I have been searching for this since few days and no luck. Thank you very much
08 August 2024 9,157 4 View
Hi all, I was just wondering if anyone has experience with multiplexing a mouse monoclonal primary and a rat primary. I'm trying to multiplex by incubating them in the same well but was told by a...
06 August 2024 9,710 1 View
i have sorted anti-NP specific plasma cells from bone marrow of C57BL/6 mice at certain times after immunization with variable counts and isolated total RNA using TRIZOL method for RT-PCR using...
05 August 2024 8,835 1 View
I will be with my students collecting seaweed samples in a marine farm and later we will process this tissue for RNA isolation and further sequencing. Does anyone have tips on how to collect the...
04 August 2024 501 2 View
I have tried several times to isolate lymphocytes from mouse spleen, but all attempts have been unsuccessful. I tried most available protocols. I used different dissociation media (HBSS with Ca...
04 August 2024 9,913 7 View
I´ve been unable to find specific information about this neurotrophin in the CNS of rabbits exclusively. There is extensive info in mice, fish and rats, but in brain´s rabbit is hard to find....
04 August 2024 762 1 View
I have been attempting to extract DNA from Bacterial, Fungal and Yeast banked samples (>1e7 cells) using Prepman Ultra reagent and I seem to be struggling to obtain a sequence. Although the...
01 August 2024 2,079 0 View
I need to lyse and homogenise mouse tissues. So far I have experimented with liver and lung tissue, using matrix D. The liver was completely lysed with 6 repetitions of the standard program, but...
31 July 2024 9,186 0 View
I need to Postfix mice brains. I slice the brains using microtome at 40 microns. These are Postnatal days 7, 11, 14, and 21. I am using half the brain for other analysis, so I need to fresh freeze...
31 July 2024 1,123 4 View