Is there any simple means to prepare Zirconia thin films
Yes. You can easily deposit ZrO2 films by means of sol-gel technology both starting from Zr alkoxides and Zr salts. Specifically, what do you need a ZrO2 film for? How "thin" do you want your film to be?
Check out this paper its a good starting point:
02 March 2016 836 8 View
PXRD data suggests cubic nature but Raman gives Monoclinic why? Which phase i can consier
10 November 2015 3,994 1 View
31 December 2014 4,661 4 View
can some one suggest a free plagiarism detector software?
31 December 2014 8,984 0 View
31 December 2014 2,593 5 View
But my material is not soluble in any liquid.
09 October 2014 8,213 5 View
Quantum efficiency
08 September 2014 1,427 3 View
07 August 2014 270 2 View
Is it possible to identify the phase of nanomaterials from FTIR spectra?
07 August 2014 7,804 16 View
I want to prepare a slurry of oxides ( ZnO, ZrO2, CuO...) and to coat them on some other metals like steel. Can some one help me out?
01 February 2014 7,109 1 View
We use reactive sputtering process to make aluminum nitride film, and want to make c-axis aluminum nitride film on a silicon substrate, but the crystal orientation cannot be seen with...
03 March 2021 7,975 3 View
I try to check the uv-vis absorption of Indium nanoparticle. Now I am measuring in solution, can I measure it in the form of a film?
01 March 2021 930 3 View
Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.
28 February 2021 3,640 3 View
24 February 2021 2,362 5 View
Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...
24 February 2021 3,785 3 View
As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...
24 February 2021 1,349 1 View
I am trying to characterize an electrochromic system. The system uses ITO electrodes on glass, WO3 as the electrochromic film, and NiO as the ion storage layer. When I deposit NiO and WO3 and...
23 February 2021 9,592 2 View
I notice that upon washing and air-drying of my RGO/SPCE surface and characterizing again via DPV, the current response towards ferricyanide probe significantly decreases. My worry is that the...
22 February 2021 5,324 3 View
I want to deposit multilayer coating of germanium and silicon monoxide on silicon wafer using ebeam evaporation?
21 February 2021 2,141 3 View
I want to measure the thickness of aluminum oxide and titanium oxide layers deposited on textured glass substates. The layer thicknesses are typically below 100nm.
21 February 2021 5,465 4 View