I am looking for transposon library in S.aureus 8325-4 strain.
I think not yet for that strain but exists for USA300_FPR3757 may be ondoing somewhere!
Jamila
Dear Karen,
You can contact Dr.Line E.Thomsen,Department of Veterinary Disease Biology,University of Copenhagen,Denmark to get transposon library of S.aureus 8325-4.His email is [email protected]
With kind regards,
Thanks for the sugestion, I didn't know. Is that published?
Best regards to all.
Thank you both very much!
I knew about the USA300 library but then all my previous experiments are in 8325-4 so I would prefer to continue with it.
I will send an email to Dr. Thomsen asap and will update the post when I get an answer!
The same problem here we started on Newman!!!
Dr. Line E.Thomsen does unfortunately not have a transposon library of S.aureus 8325-4.
I would like to find an alternative to TSB, with known composition. Thank you so much!
10 November 2017 9,801 2 View
I would like to oxidize flavins and if possible also quinones in bacterial supernatant. Is there an enzyme one could use for that? Or any other "oxidant"? I use M9 minimal medium. Thank you so...
10 November 2017 342 3 View
I would like to fix S.aureus on plastic surfaces and I cannot use EtOH or acetone since they dissolve my plastics and I would just like to try another method then formaldehyde. Than you so...
09 October 2017 4,577 3 View
I have spin coated films of PEDOT:PSS on glass (and gold) and would like to map their conductivity The films are about 150nm thick. I have tried using PeakForce TUNA (Dimension Icon, Bruker) but...
08 September 2017 6,544 2 View
I am working with PEDOT:PSS thin films that I routinely produce by spin coating on play microscope slides. For various measurements I would need to have films of different...
06 July 2017 301 9 View
I am using a conformational dye that bonds to some structures on bacterial membranes and formaldehyde fixation does not really work for me. Thanks!
04 May 2017 4,458 5 View
Upon filtering (0.2um) or ultrafiltering (3kDa) an exponential culture of Salmonella enteritidis in M9 I can measure fluorescence at the wavelengths expected for NADH. However, if I heat these...
10 November 2016 1,851 5 View
We have used hydrodynamic injection (http://www.mjhid.org/article/view/418/620) to deliver DNA to liver where we have shown with microscopy and IHC that the protein is present. We have also used...
01 February 2015 5,041 12 View
We would like to find an option to purify proteins under denaturing conditions (= 6M guanidinium hydrochloride) that is not his column (or similar, cobalt etc). Any ideas? Thanks a lot!
01 February 2015 3,486 10 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...
03 March 2021 5,978 5 View
Good afternoon, I recently used OmniLog from BIOLOG for my experimentations : I tested the metabolism of different strains on 2 types of plates. I have 16 strains of 3 different groups...
02 March 2021 3,584 1 View
Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...
02 March 2021 4,569 4 View
Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...
02 March 2021 3,024 2 View