Hi, I use the software COMSOL Multiphysics.
I would like to get the solution outputs
of the mathematical problem that I run.
Specificaly I would like to get pressure and velocity
(according to time) of the flow that is flowing through a mean.
Do I have this ability in comsol multyphysics?
Thanks in advance,
PD
yes you can. just select Time Dependent from the select study. And you can add animation from the results ribbon to view your results as animation.
I hope you find this answer useful
Yes you can do this. I agree with Saif Manji. In addition to it, use Cut-line and add plot line graph and select expression for either velocity or pressure.
Thank you, all, for your interest! Juan, the problems mean is the resin which flows along (and inside) the carbon fiber to fill the unfilled space.
It seems appropriate for porous media flow, but I've never tried that physic. When yo have your problem solved you can go to the results node and under data sets (more data sets) you can add an average operator for example, then you select where you want to evaluate your average velocity over time, it could be a point, line, surface, or a solid. Then you add a plot or a table and evaluate your variable (velocity is usually u_fluid, u -on x direction- and total magnitude is usually U) using the data set created before.
This is not the only way but is one of the possibilities. Good luck!
Perfecto! thank you!
For completeness I mention that I followed a little bit different way:
Results -> Derived Values -> Average -> Surface (my case study) Average
- Badges
- Science topic