Hallo everyone,
I am doing a dynamic analysis with Abaqus. The steps of my model is as following:
step1 static Analysis (a stepped shaft inserted in a chuck with different clamping forces)
step2 eigenfrequency analysis
step3 frequency Response analysis
modal based Steady-state dynamic analysis
The impuls force is set to 1N at the tip of the shaft in x direction which is vertical to the shaft's axial direction(Y).
I want to get the plot of frequency Response after putting the Impuls at step3.
But I don't know which Points I should select for my Output.
Instead of choosing of history Output of single Points, I selected the 'Generalized displacement'. This variable seems can only show the Response of the whole model. Then I got the Response plot of Mode 1 to 4.(see below)
Is this plot correct for using as result of the dynamic Analysis?
Or is there other variables I should use for history Output?