Is it possible to make pellet of a pure organic compound without adding binders like KBr?

More C. Ranjith Dev Inbaseelan's questions See All

Are diatom inclusions found in shellfish shells?

Mangroves were reported to eat into limestone atolls like so much cake - but could it have been diatom partnerships at mangrove roots that ate into the rock? If gypsum formation is a clue, how...

12 July 2024 159 2 View

Validated HPLC method for the estimation of the Amphotericin B ?

During the release test of Amphotericin B using 1% Tween 80, i observed three peaks even in the standard. The first peak consistently yielded results around 500%, while the other peaks showed...

08 July 2024 1,330 0 View

Issue with micrometer beam size while simulating moving heat source problem?

I am trying to replicate results published in the journal paper published recently (Modeling of Laser-assisted micro-milling Inconel718 ). In that paper, they used vdflux subroutine to obtain...

05 July 2024 3,701 0 View

How to produce homogeneous reference gene bands in Western Blot?

Hello, I have been performing Western Blots to study the protein levels of a rodent skin and muscle sample. However, I have not been able to produce homogenous reference bands. I suspect that...

26 June 2024 5,913 3 View

Do you think undergraduate teaching via online platforms like zoom is sufficient to teach theory parts of Science subjects?

When I analyzed grades of undergraduates, some course taught via online platforms, their grades are lower than the physical lectures.

11 May 2024 7,475 4 View

Why Agroforestry not popular among farmers?

Agroforestry is considered and identified as a good land management practice. But most of the farmers prefer monoculture or mixed cropping system, But not agroforestry provide lots of tangible and...

09 May 2024 2,376 2 View

Which is the correct keyword for NLO calculations?

Hello, I hope this message finds you well. I have just started to learn gaussian software. While running NLO calculations I used the keyword: #p b3lyp/6-31g(d,p) geom=connectivity gfinput...

08 May 2024 6,756 2 View

Is it necessary to incorporate deformation energy and entropy corrections when calculating MMPBSA binding free energy in Protein-ligand complexes?

The inclusion of deformation energy and entropy corrections in MMPBSA binding free energy calculations is common in studies involving DNA-ligand complexes. However, in the literature, these terms...

25 April 2024 7,286 0 View

How to do Thrips Egg staining?

In order to view/ find the laid thrip eggs is there any methods is available, if yes, suggest me the methods.

23 April 2024 7,873 0 View

Would like to learn about Auguste Levasseur, Lafayette's friend and author of the book on their visit to the United States in 1824-25?

The Marquis de Lafayette is "returning" to America again this fall. After serving in the American and French Revolutions, he returned to America in 1824-1825 and toured some 25 states. This...

19 April 2024 4,979 0 View

• What the possible Persistent Organic Pollutants and Heavy metals present in fluorspar, sediments, and water bodies around its mining area?

Approximate concentrations are require in compared with the WHO permissible limts

11 August 2024 2,723 1 View

I have get this error when i calculated the geometrical optimization for prco3, it takes 12 hours until gives this message in the outputfile?

Fatal error in MPI_Allreduce: Other MPI error, error stack: MPI_Allreduce(1628)......: MPI_Allreduce(sbuf=000002459254A180, rbuf=000002459F86A140, count=4851, MPI_DOUBLE_COMPLEX, MPI_SUM,...

09 August 2024 7,615 1 View

Basis set and input instruction to calculate HOMO and LUMO using Orca for Imidazolium based organic salts?

Hey there, As a synthetic chemist delving into theoretical calculations for my imidazolium-based organic molecules, I would greatly appreciate any guidance on the appropriate input instructions...

09 August 2024 5,444 7 View

I can't see the ssDNA band after performing asymmetric PCR. Is there any way to do this?

After performing symmetric PCR, PCR purification was performed. Afterwards, asymmetric PCR was performed using the PCR purification product as a template, but no ssDNA band was confirmed in the...

08 August 2024 1,668 3 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

What is the prepared reference material that can be used in inductively coupled plasma optical emission spectrometry (ICP-OES) to measure REE and U ?

What is the prepared reference material that can be used in the ICPE-9820 Shimadzu Japan instrument, which employs inductively coupled plasma optical emission spectrometry (ICP-OES) to measure...

06 August 2024 1,896 1 View

How to understand this crystallographic phenomenon of low temperature crystals in zeolite?

During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...

06 August 2024 726 3 View

How effective is the Citi Bloc standard basket in enhancing the accuracy and comparability of international construction cost assessments?

Citi BLOC Standard Basket Definitions: A standardized unit representing a fixed basket of construction materials, labor, and equipment costs priced in various cities. Purpose: To create a common...

04 August 2024 8,997 1 View

How to convert g/kg Humic acid dose to kg/ha?

I used humic acid at 0.044 g/kg soil in my pot experiment. But finally, I have to recommend kg/ha. Each pot's soil weight was 11 kg. What is the solution?

02 August 2024 7,186 6 View

How to improve peaks separation in HPLC?

Hi everyone, I'd like to better separate two close peaks coming from a bioconversion sample, I'm currently using a C18 KromaPhase 4,6mm Ø.I. SCHARLAU, particle size (µm): 10, pore size (Å): 100,...

30 July 2024 435 3 View

Syed Zameer Abbas

It depends what kind of compunds you want to compact and for what purpose?

Certain organic materials can be pressed or simultaneouly pressed and heated to some higher temperature in a die to make a pellet/compact. I don't know if that is applicable to materials you are working with.

C. Ranjith Dev Inbaseelan

Since i have to measure the electric property, i need to use the pure material only so am searching a way sir. Thank you for the suggestions.