Is it necessary to publish the new record?

27 November 2024 1 939 Report

We often find new zones, hosts, geography, and country and state records of fungi. How far we are spending our valuable time on it. If it is a new record, we need to mention the latest feature from the existing one in a short note, or we copy all the information, including photo plates and add the latest information.

Are we just replicating the same information showing unlimited times?

Are we confusing the reader to find what is new in the ocean of copied information?

Juan Leonardo Tejada Hinojoza

Es necesario realizar nuevos registros de hongos y bacterias debido a la utilización de las pruebas moleculares que unido a la caracterización morfológica, hay mayor precisión en la identificación/nomenclatura fungosa.

Badges
Science topic

Similar topics
Education
Students

More Niranjan M's questions See All

Is there any cases algae not using the nutrient from the wastewater and grow normally?

I am working on microalgae cultivation using waste water. The initial concentration of nutrients were less but the microalgae has achieved biomass growth of 2 g/L. The final concentration of...

08 August 2024 4,812 2 View

I have calcined my catalysts without flowing air from the compressed air cylinder will there be any problem with my reaction if i use that catalysts?

FYI Catalyst is MFI zeolite Si/Al = 140,25.40.11.5,15 I am using this catalyst to study methanol to DME conversion

25 July 2024 2,486 2 View

How can I measure arsenic concentration in a patient blood?

I intend to get an economical and accurate LAB TEST to measure arsenic concentration in blood sample.

23 July 2024 3,654 2 View

It is possible to conduct a structured written interview for a qualitative study?

In your opinion, I would like to know if a qualitative study with a structured interview can be conducted in writing. In other words, we sent out open questions and asked the interviewees to...

11 July 2024 4,163 4 View

What is Differential-Fed in microstrip patch ant? How it is design in CST studio? What is process and procedure to do Differential-Fed in CST studio?

What is Differential-Fed in microstrip patch antenna ? How it is design in CST studio? What is simulation process and procedure to do Differential-Fed in CST studio ?

08 July 2024 7,464 1 View

How to know the TM/TE modes in antenna design in CST studio?

How to know the TM/TE modes in antenna design in CST studio? Example: TM01 ,TM02 ,TM10, TM12, TM30 like this... how can identify the antenna is operate the above said mode? can any one explain...

08 July 2024 6,609 2 View

What is co-polarization and cross polarization? How can plot it from CST studio?

what is co-polarization and cross polarization? How can plot it from CST studio? what are steps and process for find out co-polarization and cross polarization from CST studio?

08 July 2024 7,869 1 View

Why in some degradation experiment the results doesn't fit first or second order kinetics ?

In an antibiotic degradation experiment using metals carbon composites to activate PMS, the results doesn't fit pseudo first or second order kinetics however the degradation efficiency is very...

26 June 2024 6,941 3 View

Why carrier Concentration decreases while increasing Temperature ?

Hi All . Recently, I conducted Hall measurement experiments at high temperatures on highly p-doped diamond with a doping concentration of 2.5×10^20 cm−3 During these experiments, I observed two...

23 June 2024 4,763 0 View

What are the best practices for increasing earth biomass?

I'm thinking of how to increase biomass to replace plastic and industrial waste.

23 June 2024 1,871 4 View

How can I apply boundary conditions in an orthotropic steel deck numerical model using ABAQUS software?

I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...

08 August 2024 719 0 View

Does crude extraction using NaOH and Tris work well with Fungi?

I'm trying to find a DNA extraction method for fungi that does not require equipment and heating. Is there anyone who can suggest an alternative option? Thank you

08 August 2024 4,733 2 View

Unusual intensity drop in some sections of chromatograms in DDA?

Hi, we have measured tryptic peptides using both DDA and DIA method on QExactive. In DDA replicates i saw unusual intensity drops occurring at the same sections of chromatograms in DDA replicates...

07 August 2024 3,218 4 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

What is fitofthora instance of potatoes?

Now research fellow used it to prevent fungus in potato,may be potatoes gene effect.

02 August 2024 180 3 View

What is gangrine? Is there gangrine happened indie potato?

Please discuss someone told about fungus and allied others.

31 July 2024 3,372 3 View

Question about Single Strain Arbuscular Mycorrhiza Fungi??

Now i am working on AM fungi single strain. What are the most effective isolation techniques for obtaining pure cultures of arbuscular mycorrhizal (AM) fungi?? Is there are best approach...

26 July 2024 6,520 1 View

Does anyone know a source for theta-replicating Staphylococcus plasmids that are compatible?

I am trying to put 3 separate plasmids into Staphylococcus aureus and I am looking for those that are theta replicating and compatible. I have obtained pSK9065 (from pSK1) from Addgene, but the...

23 July 2024 6,968 0 View

Has anyone calculated the effective concentration at 50% (EC50) value of different fungicides for the fungus Tilletia horrida?

How can we measure their colony diameter?

12 July 2024 7,027 0 View

I am carrying out an experiment on Trichoderma. How can I measure OD of the fungal growth after 7 days?

I am carrying out an experiment on Trichoderma and need to measure OD of the fungal growth after 7 days. Unlike bacteria, fungus clump together making It difficult to get OD for the fungal growth....

11 July 2024 6,251 1 View