Is C60 soluble (ca. micromolar) in mesitylene or 1,2,4-trichlorobezene
The solubility of C60 in 1,2,4-trimethylbenzene is 18 mg/mL.
It's also soluble in TCB and many other solvents, check out the full review here:
Article Solubility of C 60 Fullerene
Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?
06 August 2024 980 5 View
Hello everyone! I am currently exploring the performance of large models in understanding knowledge in specific domains, and attempting to construct a knowledge framework similar to what...
05 August 2024 5,729 2 View
Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity? What is the acceptable percentage of error (regardless of the metric)? Could you suggest...
03 August 2024 5,358 0 View
need to open an account to upload my published papers
01 August 2024 9,255 1 View
All plants are green but some of these plants becomes yellow. I did not found any reason. Please help me to find out the real problem.
01 August 2024 589 4 View
I am using a Bruker 600M solid-state NMR spectrometer with a Micro 2.5 microimaging system. The test sample is a tube of 1M LiCl aqueous solution, and the nucleus detected is 1H. I am trying to...
01 August 2024 9,227 1 View
Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...
30 July 2024 9,824 2 View
N=6 Comparing pre and post test likert scale responses. Participants are mix of practicing & preservice teachers.
30 July 2024 7,233 4 View
Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...
30 July 2024 906 2 View
Can an analytical method's limit of quantification (LOQ) be outside its linear dynamic range, or is it always required to be within it? Please provide a thorough explanation supported by verified...
29 July 2024 7,198 9 View
..
05 August 2024 4,407 0 View
Hello everyone, I am try to understand the differences interaction between insoluble and soluble polymers in water with metal ions and how theit charge density (of metal ions) affect the interaction.
29 July 2024 6,350 3 View
Dear all: I am modifying Bismuth Tungstate with Hematite (Fe2O3), so I would like to know about how much Iron(+3) can form a solid solution in a Bismuth Oxide matrix. Best wishes Marco
29 July 2024 2,163 1 View
I was performing estimation of Total Soluble Sugar content in bacterial cultures by Anthrone method. Out of 9 samples, only one sample showed positive reading while others had a negative reading...
22 July 2024 9,576 4 View
Hi Dear Researchers, Could anyone please provide me with some information about the HPLC column, specifically the “Purospher STAR RP-18 LiChroCART Cartridge”? I would like to know if it is...
25 June 2024 9,523 1 View
I have ChemDraw 22.2.0 and I want to draw PC70BM but I just found C60 and less in the templates so, any one can help me ?
18 June 2024 3,098 3 View
I have a set-up were I have a bottle with water (DI water, 0.8uS/cm). To that bottle I have added some MgO nanopowder, at a concentration of ~ 0.08mg/ml. It appears that the white powder is...
04 June 2024 9,789 4 View
I want to determine if a particular monomer does not dissolve properly in my reaction solvent , N,N-diemthyl acetamide.
27 May 2024 643 3 View
Dear colleges, Does anyone know solubility of Fe(NO3)3x9H2O in acetone g/100 ml Thanks in advance Branimir
26 May 2024 2,383 2 View
I am trying to synthesize Cu3P, but I am encountering difficulties with the solubility of red phosphorus in water and various organic solvents. What should I do in this situation? Could anyone...
24 May 2024 7,753 2 View