What is the nutrient requirements for E.coli BL21 CodonPlu RIPL strain growing in M9 medium?

Hello. I want to isotopically label the my protein, and I express it in BL21 RIPL using M9 minimal media. It grows extremely slow. I inoculate the colony from a fresh M9 plate into 5ml M9 medium...

17 February 2021 2,852 2 View

Do you have experience of second round PCR amplification issue?

When 1st-round PCR amplification was finished , I could get a clear expected band, but the amount was very low, so I cut the band and run second-round PCR with same condition, it didn't work, I...

21 January 2021 888 4 View

Can someone recommend me a classic book of liquid crystals?

I am currently into liquid crystals and have no related background. Can someone tell me which book is the most instructive one to learn basics of liquid crystals? I am more interested in different...

22 November 2020 4,362 6 View

How does the influence of metal ions on the fluorescence intensity of a compound?

We found an interesting phenomenon that metal ions could not influence the fluorescence of a compound when the compound was dispersed in solvent. However, the fluorescence of the compound was...

31 October 2020 6,568 3 View

Is K-silicate gel a porous material?

I coated a stone surface with K-siilcate. Apparently, it does noe seal the surface since the water penetrae the stone easily and the absorption coefficient does not change too much. However, the...

05 October 2020 3,435 5 View

Fluent how to draw a graph of coordinate changes over time?

When simulating waves, it is necessary to detect the coordinate change at a certain point of the wave surface, but there is no in fluent.

04 October 2020 1,541 1 View

How to quickly know the new research area landscape and find a research gap in this new area?

As a Ph.D. candidate who enters a new research area that differs from the research topic in the master period (e.g. shift form crop breeding to soil ecology), how to quickly know the new research...

23 September 2020 8,131 5 View

How to build epoxy model in GAFF for Lammps?

Dear all, I am a beginner in Molecular Dynamics. I build a pre-reaction epoxy model using Materials Studio and plan to perform the cross-linking procedure using Lammps. However, the msi2lmp tool...

26 August 2020 7,697 1 View

How to detect brown pigments generated in red wine aging process ?

During aging or storage, the concentration of monomeric anthocyanins decreases rapidly, while low level of polymeric anthocyanins generates, and the color of wine turns brick-red gradually. In...

17 July 2020 6,032 4 View

How to define the particle agglomeration in composite materials or foundry alloys and measure its size distribution quantitatively?

28 June 2020 7,614 3 View

How the Ground Plane implantation is performed without damaging (and w/o varying the undoped nature) the top Si (8-10 nm) in FDSOI technology ?

It is a general practice to introduce Ground Plane in FDSOI devices under the BoX. The Ground Planes are introduced by Ion Implantation through Top Si layer and Buried Oxide. I wanted to know that...

24 February 2021 5,974 4 View

How to delaminate copper in water-based anodes?

Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...

24 February 2021 3,785 3 View

How to find natural frequency of a bridge from vehicle induced vibrations?

i have frequencies of bridge that are effected by mass of vehicle. the problem is when any vehicle pass the bridge it would add the its mass to the bridge mass ultimately mass of the bridge will...

22 February 2021 10,004 3 View

How to dissolve cross-linked Amberlite IRC120 H, hydrogen form resin?

Hello all, I have used Amberlite IRC120 H, hydrogen form acidic cation-exchange resin for the ion-exchange of waterglass [sodium silicate solution -- 40% Sodium silicate (mol ratio > 3.2)...

21 February 2021 5,614 3 View

The Role of Town Planners in CAV Use?

Colleagues and I are about to begin a project investigating the role of town planners and local authorities in establishing the introduction of connected and autonomous vehicles (CAVs). What...

21 February 2021 2,247 3 View

How to prepare electrolyte of NaClO4 salt for Na-ion battery? Any problem with this salt?

Hello, I am trying to make anode for Na-ion batteries. I have no experience with preparation of the electrolyte for any batteries. NaClO4 salt are available and I am planning to use EC:PC as...

21 February 2021 8,132 1 View

Where can the fault diagnosis data set of lithium battery be found?

Most of the data sets on the network only contain good information about the voltage and internal resistance of lithium batteries. The data of faulty battery is missing. Who can help me, I will be...

21 February 2021 8,659 1 View

Not able to charge-discharge Li-ion coin cell at higher C rate ?

I am working on cathode material. I have made different Li-ion coin cell against Li metal using commercial available cathode materials such as LCO,LMO, LFP and NMC and also with the lab...

18 February 2021 1,450 3 View

No title

Hello. I ask for help - I need to get lithium tetraborate (soluble salt) from lithium carbonate and boric acid. In literature, everything seems to be simple - mix, ignite and - it's done. But it...

16 February 2021 9,523 2 View

How to Measure Consumer Willingness To Change from petroleum-fueled vehicle to electric vehicle?

I wanted to calculate the probability of one consumer shifting from using a petroleum-fueled vehicle to an electric vehicle. Since my background is in engineering I do not know much about how to...

15 February 2021 9,190 5 View