the specification of PT slab:
flat plate 9" slab (300' x 60'), 270 cables type mono strand, 1/2" dia 7-wire strand, E=28500 ksi, fpu= 41.3 kip. f jaking 70% fpu.
Length cable = 231' type banded type, the cable passed over eight columns).
The question is , in case damage in cable cause cut, how far it will goes out of edge slab, is there in equation shows that, the distance will be from slab edge measured.
Be noted based on EXPERIMENTAL OBSERVATIONS, this cable didn't went out so far, so, I need to know which equation give in inches?
The attached picture shows four banded groups, its first cable from the right.
In Post Tension continuous beams 9" Slab thick, how far will the cable goes out of slab edge?
- Badges
- Science topic
More Ehab Al Timimi's questions See All
Similar questions and discussions