Hypereutectoid steels
Grain boundary structure
High Entropy alloys are considered as a breakthrough in the present generation of materials science but what if all metals(in solid state) in periodic table would have been mixed, would that still...
02 March 2019 9,290 8 View
Particle stimulated nucleation
11 December 2018 8,064 0 View
HEAs, CNTs
09 October 2018 5,715 1 View
It is already known that metal carbides, oxides and nitrides possess crystal structures which do not have sufficient slip systems for dislocation movement during plastic deformation. However,...
06 July 2018 4,739 5 View
its simply known that in in binary alloys, during eutectic solidification,if we consider alpha(A rich) solid solution then it grows by diffusion of A atoms which are found to be rich in...
05 June 2018 1,521 4 View
Although the reverse phenomenon is expected to be observed...
05 June 2018 8,687 6 View
CNTs
05 June 2018 939 2 View
Solidification
31 December 2017 5,026 0 View
powder metallurgy
11 December 2017 2,735 2 View
Related to slag chemistry in ironmking
10 November 2017 1,549 4 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...
07 August 2024 5,177 3 View
Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container
30 July 2024 7,326 1 View
Excavation in 2007 in Northern Scotland along the East Coast revealed a domestic site containing the unbroken half (other half is missing) of a perforated circular disc measuring L 37mm x W...
27 July 2024 6,019 0 View
Any suggestions with respect to etchant composition and holding time?
27 July 2024 6,925 2 View
The catalytic effect of retained austenite refers to the phenomenon wherein quenching steels with a small amount of retained austenite, when subjected to tempering at a specific temperature...
27 July 2024 8,508 0 View
Please investigate the effect of temperature and strain rate of hot deformation and the formation of delta ferrite in martensitic stainless steel 410?
25 July 2024 9,408 0 View
I have tried to saturate ferritic steel with hydrogen using the electrolytic method and H2SO4. However, the effect was very poor even after 3 days of "saturation". Can anybody help in choosing a...
24 July 2024 4,393 2 View
