In nanoparticle synthesis using reverse micelle, how will the nanoparticle be extracted from the water pocket of the reverse micelle?

More Bhubesh Murugappan's questions See All

Can we have glucose sensors without employing electrochemical means?

Hello, I am looking for glucose sensors. I have used Brilliant Yellow as a pH sensor and now I am looking for a solid, powdered substance that can act as a glucose sensor (such that the intensity...

05 June 2018 4,459 1 View

Why does PDMS solidify on heating? Will Alginate also solidify on heating?

In general, as temperature increases, the viscosity of liquid solution decreases and it should exhibit more liquid behaviour. But the case of PDMS is quite opposite. On increasing the temperature,...

05 June 2018 5,062 4 View

What is the difference between degradation of polymers at low temperatures and degradation of polymers at high temperatures?

Can anyone point out the difference between degradation of polymers at low temperatures (around -150 degree celsius) and degradation of polymers at high temperatures. And also can anyone highlight...

04 May 2017 6,863 10 View

How to increase the aspect ratio in the case of nanorods?

I am presently working on the synthesis of ZnO nanorods. I would like to know on what factors does the diameter and length of the nanorod depend upon? Is it dependent on pH, temperature, retention...

04 May 2017 9,175 1 View

Can excess amount cerium sulphate be dissolved in water using sonication?

Well, I have been recently dissolving some salts into water using sonication technique (especially when the amount of solute is very high). I had the notion that by using sonication technique, the...

02 March 2017 6,637 7 View

How does Thermal conductivity of nanofluid change with decreasing particle size of the dispersed nanoparticle?

Some papers, mention that with decrease in nanoparticle size, thermal conductivity of nanofluid increases. But some papers mention the same in the opposite way, that is, thermal conductivity...

02 March 2017 4,188 2 View

Lower Critical Solution Temperature for water oil system?

We know that below the Lower Critical Solution Temperature,components of the mixture are completely miscible in all compositions.Then does such a temperature exist for the Water-Oil system?...

11 December 2016 3,797 0 View

What effect will the nanoparticle size have on surface plasmon resonance?

It is known that increasing the size of the nanoparticle, increases the wavelength at which surface plasmon resonance occurs? But can anyone let me know what is the reason behind this? And how...

10 November 2016 7,524 4 View

Hello researchers Is this a random laser or just fluorescence?

I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.

09 August 2024 9,894 2 View

How to prepare the nanoparticle treated fungal sample for Environmental SEM analysis?

A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.

07 August 2024 5,307 1 View

Binder for ZnO nanoparticles in graphite paste electrode?

I have been using paraffin, but the deposited ZnO still detach from electrode. What is the best binder to modify graphite paste electrode with ZnO nanoparticles?

03 August 2024 4,624 3 View

How to start a Molecular Dynamics Simulation?

Is it possible to conduct a molecular dynamics simulation to see the effects of a specific carbohydrate on the structure of lipids (e.g., micelle structure)? I am a beginner in this field and plan...

03 August 2024 3,371 3 View

Can i quantify a nanoparticle encapsulated in cell culture medium by hplc?

Hello, if you made a transwell assay where you incubate the cells with a nanoparticle-encapsulated drug and considering that in the oposite compartment you'll have both the free and encapsulte...

03 August 2024 2,730 1 View

Mossbauer spectroscopy Co0.6Mn0.4Fe2O4 MNPs?

Following curve related to Co0.6Mn0.4Fe2O4 Magnetic nanoparticles with extra phase a-Fe2O3. I will appreciate to help me to interpretation this spectroscopy, especially the blue line.

31 July 2024 9,140 2 View

What is the reason I get 400nm nanoparticles using an extruder with 200 nm membrane for cell membrane coating?

I am trying to coat my micelles and PLGA based nanoparticles with cell membrane using an Avanti mini extruder according to literature . I use 200nm membrane but my particles end up to be 400nm And...

30 July 2024 3,294 3 View

Addition of EDTA during the synthesis of copper nanoparticles to prevent it from being oxidized?

I've attempted to use this method to synthesize copper nanoparticles. Copper nanoparticles can be synthesised using a variety of precursor materials. CuSO4, distilled water, NaOH, and EDTA are...

28 July 2024 8,027 3 View

Optimal siRNA Volume for Complexation with Liposomes in a 2.5 mL Solution with 10 mg/mL Lipid Concentration?

How much volume of siRNA can I add to 2.5 mL of liposomes with a total lipid concentration of 10 mg/mL?

27 July 2024 6,920 1 View

What are the modern methods for detecting nanoparticles?

Some of the techniques I am familiar with are standard. I would like to know which of the two methods under study is preferable, as well as the cost and list of particles and devices needed in...

22 July 2024 1,921 3 View

Yuri Mirgorod

See our article

Relationship between size of cadmium sulfide nanoparticles and water pool diameter in reverse micelles

Best regards

Dario Rivera

Yes you can use centrifugation or add more water to break the micelles and then centrifugation.

Sergei Nikolaevich Shtykov

I agree that it is need to break micellar solution and there are many ways to do that.