19 March 2024 1 8K Report

I have data of CV and GCD. When will i calculate a specific capacitance or specific capacity? Also give information about their formula. please help me find energy and power density or recommend any paper.

More Muhammad Tayyab Iqbal's questions See All
How combine yolo with Faster R-CNN?

I want a model that is balanced with accuracy or speed, faster rcnn has high accuracy while yolo have fast speed. i am thinking to combine them to get a hybrid model to achieve both speed and accuracy

02 August 2024 3,104 0 View

What should be the sample container for the hydrothermal reaction in a microwave reactor at 180 °C for 10 min at the heating rate of 5 °C per minute?

Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container

30 July 2024 7,326 1 View

Addition of EDTA during the synthesis of copper nanoparticles to prevent it from being oxidized?

I've attempted to use this method to synthesize copper nanoparticles. Copper nanoparticles can be synthesised using a variety of precursor materials. CuSO4, distilled water, NaOH, and EDTA are...

28 July 2024 8,027 3 View

Can I please ask why my samples from anaerobic bioreactor giving me different size PCR product even after multiple runs?

Hi everyone, I have extracted DNA from a biogas bioreactor using Qiagen kit and prep cDNA library then used this library as template to optimize primers for qPCR (taken from papers). Some of the...

23 July 2024 1,329 5 View

Swerling Characteristic functions?

Hello!!! I want to implement the Swerling characteristics functions (CF) directly in MATLAB without using its Fourier integral pairs...the Swerling CFs are actually Laplace Transform of the signal...

23 July 2024 4,925 1 View

Radar Detection Probabilities?

Currently I need to calculate detection probabilities (PD) from RCS data. Beta distribution parameters for this RCS data are calculated and will be used in Swerling0 Equation. The idea is based on...

22 July 2024 2,851 0 View

Why methanol and sulphuric acid used in the analysis of polyhydroxyalkanoates (PHA) by GC-MS?

Why methanol and sulphuric acid, used in the analysis of polyhydroxyalkanoates (PHA) methyl esters by GC-MS? Additionally, why do we typically use non-polar solvents in GC-MS?

22 July 2024 1,210 2 View

Radar Detection Probabilities using beta distributed Scattering Cross section?

Currently I need to calculate detection probabilities (PD) from radar cross section (RCS) data. Beta distribution parameters for this RCS data are calculated and will be used in Swerling0...

22 July 2024 868 0 View

I want to buy Hydrothermal Synthesis Autoclave from any European company. Can anyone suggest any company inside Europe?

Thanks

22 July 2024 1,143 3 View

Optimal condition for depositing FTO target 95:5% using sputter technique?

Hello I want to know about the sputtering condition of depositing FTO from target 95:5%. I tried with RF sputter in pressure 2.5Pa and 100 sccm Ar at room temperature but it showing no...

21 July 2024 1,680 2 View

Similar questions and discussions
Why specific capacitance is not proportional with the specific surface area?

Dear researchers, Why specific capacitance is not proportional to the specific surface area? I have material A with a surface area higher than material B, but material B is showing little bit...

26 July 2024 9,156 2 View

Does the specific capacitance value decrease or increase over time?

Will these measurement results change, for example, 1 month after the first measurement (e.g. CV, EIS) of the electrode or supercapacitor device? If it changes, how will it change? Is there an...

03 July 2024 3,644 2 View

What is the capacitance of Glassy carbon electrode?

I need to calculate the time constant which requires the capacitance of the glassy carbon electrode.

01 July 2024 1,087 2 View

How to predict the efficiency of a very low speed Railgun Actuator/Lorentz Force Actuator?

I'm not an electrical engineer or anything related to that subject, so my apologies if I understood something incorrectly. Well, I read somewhere that the slower the railgun is, the higher its...

23 June 2024 1,082 0 View

Why capacitive current is so high (40A-80A) in the modules?

I recently measured the very high capacitive current in solar modules (Usually very small, i.e., in mA). 2 devices were burned during the measurements. Can anybody explain the reason for a such...

05 June 2024 4,489 0 View

¿Cual es la Definición conceptual de competencias parentales?

Referido a las capacidades de los padres para la crianza de sus hijos.

22 May 2024 9,122 0 View

Can specific capacitance increases with increase in current density?

In my case , as i increase the current density the specific capacitance of the electrode is increasing. Also, I am getting the least capacitance in case of 1 A/g and maximum at 10 A/g. Can anyone...

19 May 2024 1,422 0 View

When we measure capacitance with an LCR meter in series or parallel mode, what do series or parallel mean in this context?

How does an LCR meter works? When we measure capacitance with an LCR meter in series or parallel mode, what do series or parallel mean in this context? What components are in series or parallel?

16 May 2024 823 0 View

What can we infer from electrochemical impedance analysis?

what is chage transfer resistance? Is any relation between electric doubl layer capacitance of impedance study and specific capacitance of CV analysis?

16 May 2024 3,555 0 View

Is there any formula which is used to calculate the value of capacitive contribution in the case of battery type electrode?

Dunn's equation should not be used in the case of a battery-type electrode, according to a paper published in the journal "Phys. Chem. Lett. 2020, 11, 9846–9849 (ref. attached)" that I recently...

12 May 2024 3,261 0 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close