and the colour after extracting the nanocellulose
Attached article may solve your purpose.
Thanks
Amit
Currently I am studying the absorption behaviour of multilayer thin film sample using XRF.The thin film has 3 layers ( WC/Co as substrate, Ti(C,N) as middle layer and Al2O3 as top layer). Here...
26 June 2024 6,065 2 View
In AHP (Analytical Hierarchical Process) using 9 criteria, when I use a a scale of relative importance (1-9), I am getting a higher lambda-max and hence an inconsistent Consistency Ratio (>.10)...
16 June 2024 1,228 1 View
Have you noticed any obvious change in student behaviour and learning styles after the widespread use of AI tools?
22 February 2024 7,980 1 View
Other than cross sectional studies, I wish to gain knowledge in calculating the sample size for interventional studies as well as calculate sample size with the help of Standard Deviation etc..
04 February 2024 2,011 3 View
Does Heterogeneous Bipolar transistor (HBT) has a sub-threshold voltage? Does it has performance on the structure?
13 January 2024 9,702 1 View
I am planning to take GDP (current), Real Inflation rates, Real interest rates and exchange rate fluctuations for four countries USA,UK, India and Japan. Would I be able to analyze the data using...
27 August 2023 3,652 10 View
For my dissertation, I am looking to explore the effect of Monetary Policies set by Central Banks on inward FDI (% of GDP) for USA, UK, India and Japan from 1993-2014. During this time period I...
11 August 2023 671 4 View
I am not getting the inefficiency values in STATA.
09 July 2023 6,627 3 View
I have 95% curcumin material with me I need to make water soluble products SO please help to get the idea about he formulations
18 June 2023 407 1 View
Please, is there a way to calculate collection charge for a device in silvaco tcad? Also, can silvaco tcad determine Electromagnetic interference of a device?
01 May 2023 1,101 0 View
I have a response variable called skin yellowness, which I will measure via a scored color chart, whereby 1 is pale yellow and 15 is orange. I'm not sure if this counts as an ordinal variable,...
11 August 2024 4,793 1 View
I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...
10 August 2024 8,539 5 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.
07 August 2024 8,782 3 View
Greetings When one is to perform Simulation or modelling of Pyrolysis of Biomass Waste materials using Aspen Plus software, and one has both the macromolecules breakdown (Cellulose, Lignin and...
06 August 2024 5,023 1 View
Palmitic acid presence in aqueous fraction
05 August 2024 8,624 4 View
Dear readers, Thanks for your attention. I am wondering about the health economic problem of quantifying the value of interventions which a) prevent, b) improve symptom profile and c) ultimately...
05 August 2024 3,246 1 View
I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...
03 August 2024 4,725 2 View
I am conducting a systematic review and meta analysis; as I am extracting data I realized there is a consort diagram that shows the number of patients from randomization till end of the study. So...
01 August 2024 9,993 3 View
99% pure ethanol was used for maceration also alternate methods along with the temperature and time to concentrate the extract can be specified
31 July 2024 5,113 4 View