I need an explanation of how to add a study of "Coefficient Of Performance(COP)" into the thermoelectric cooler model. I have attached my current working file below.
In the links below, you can find some information about Thermoelectric Cooler Designs:
https://www.comsol.com/blogs/how-to-analyze-thermoelectric-cooler-designs-with-a-comsol-app/
https://www.comsol.com/paper/download/199833/aliabadi_paper.pdf
https://www.comsol.com/paper/download/199835/aliabadi_poster.pdf
Lakshan Gunasinghe please follow the links attached herewith and the steps :-
Regards
We have three animal groups including a control (C) and two treatment groups (T1&T2) and we are doing this study to measure the variation of expression of a target gene . We extracted total...
01 August 2018 2,828 1 View
I would be much grateful to anyone who can give me an answer to the following question. What are the main sources to check alpha glucosidase inhibitory activity?And why it is important to carry...
26 December 2017 5,027 3 View
13 October 2016 6,157 5 View
Are there any inscriptions in Asia, similar to the King Asoka's Damma Inscriptions ?
10 April 2016 6,872 9 View
We are designing high power traction inverter to drive three phase PMSM. When operating at 330Vdc bus voltage we see the gate signal toggling but IGBT is not responding. Please see the photo...
09 February 2016 1,336 2 View
Hi, im trying to make a projection in a 3d comsol model. I have a non uniforme chanel and my intention is to get the average tempreture in the y-z cross section and se the average tempreture...
02 March 2021 4,624 4 View
How to do Piezoelectric coupling in ANSYS-APDL or COMSOL between tapered substrate and rectangular piezoelectric patch? Piezoelectric coupling between the rectangular substrate and rectangular...
02 March 2021 9,833 3 View
I have been trying to simulate heat transfer problem in Comsol 5.5 for long time but it always throw an error stating: "Failed to find a solution. Maximum number of Newton iterations...
28 February 2021 8,626 3 View
I want to measure change of capacitance due to relative displacement between two parallel plates in COMSOL. Distance between two plates changes with time. So I'm using a time dependent study but...
26 February 2021 8,567 3 View
Dear respected researchers, while performing CFD analysis in Comsol it's showing like this Error: Nonlinear solver did not converge. The maximum number of Newton iterations reached can...
24 February 2021 249 3 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
Here I am facing this problem. I don't find any effect of this type of parameters. I am a beginner user of COMSOL.
23 February 2021 9,086 3 View
I am using COMSOL Multiphysics 5.5. I am trying to simulate the tensile test of PCL scaffolds. However, regardless of the strain, I have the elastic region all the time which is not true when it...
23 February 2021 4,050 1 View
Is it possible to implement FBM in a commercial FEA software package, such as FEMLAB, COMSOL, or open source software like Moose?
22 February 2021 2,968 1 View
How to build fluid structure interaction simulation for elastic ring squeeze film damper in COMSOL?
22 February 2021 5,408 1 View