Hello friends,
I have been trying to simulate the deep drawing process in ABAQUS CAE. The uploaded image shows a schematic illustration of this process at the assembly module. In this simulation, I want to apply displacement to the punch with two types of motion simultaneously. The first type is axial displacement equal to 30mm in the y-direction, and the other type is sinusoidal displacement in the x-direction. You can see the boundary conditions tab in the image. In this case, two simultaneous displacements, I face with an error that says:
"one node has dof on which velocity/displacement/acceleration/base motion, etc. constraints are specified simultaneously. The nodes have been identified in node set ErrNodeBCRedundantDof."
What is the problem? however, there is no mismatch in the boundary conditions.
How can I solve this problem?
- Badges
- Science topic
- Similar topics
- Geoscience
- Cartography
- Mapping
- Maps