How to sequence for flowshop via Cross-Entropy Method?

MengChang Wang @MengChang_Wang

09 September 2013 0 252 Report

The Cross Entropy method is fast.

However, many articles assume that variables obey pre-determined distributions, eg, Bernoulli Distribution.

But how can I construct/select a proper distribution when sequencing a flowshop?

Badges
Science method

More MengChang Wang's questions See All

Do you eat transgene foods in your country?

There is a fierce controversy over food produced using gene technology (transgene food) in China currently. Some specialists insist that the transgene technology is similar to hybrid technology...

09 October 2013 3,218 0 View

Do you still agree with those "future research suggestions " in you own articles that were published years ago?

Various reasons lead those suggestions to no end. If you have these suggestions, do you still agree with them? Why did you stop continuing the research on them?

05 June 2013 5,764 1 View

What do you think about the journal Computers & Operations Research?

COR, is a journal on the application of computers and operations research techniques to problems, and its Impact Factor is 1.72 (with a 5-year IF 1.98). In a journal list approved by my...

04 May 2013 9,930 2 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

Issues with Permeabilization during Flow Cytometry?

Hello Everyone. Currently I am working to characterize macrophages in the myocardium after ischemia-reperfusion injury in rats. Due to the low total cell number isolated from rat hearts I can...

01 March 2021 3,867 3 View

Is it possible for two human neuronal cell lines to have different gene sequence for the same protein?

I am looking at the ATP1A2 (Sodium/Potassium ATPase alpha subunit 2) in two human neuronal cell lines. Expression levels of this protein seems to be almost equal when detected by one antibody....

01 March 2021 3,607 3 View

Runs of nucleotides in Sanger sequencing?

I performed site directed mutagenesis, transformation, and then I sent out plasmids for Sanger sequencing and found out that there is extension of DNA just before the stop codon. I am not sure...

27 February 2021 547 3 View

Has anyone used the Illumina ITS1 primer sets?

Hi everyone, Illumina provides a list of primers to amplify with high taxonomic coverage the ITS1 region for further fungal sequencing, but I cannot find the exact amount necessary of each...

25 February 2021 6,969 3 View

Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

Unknown debris sheets observed in cell culture flasks?

Hi, We culture neural progenitor cells in T175 culture flasks coated with PLO-Laminin. We have successfully grown these cells with our protocol for months. Recently, we observed large sheets...

25 February 2021 3,443 4 View

Errors in DNA sequences?

I am trying to better understand the scope of DNA replication and sequencing errors, e.g. 1. I have seen similar error rates of 10e4 to 10e5 for cell & instrumental DNA replication,...

24 February 2021 4,397 3 View

Can the problems of overfitting be solved without cross validation?

For an overfit data set the cross validation error will be much bigger than the training error. Is it true or false?

23 February 2021 3,616 2 View