28 November 2021 7 4K Report

In most of the literatures Gas Chromatography has been used to calculate the yield % of aldehydes, is there any other ways?

More Gitumoni Kalita's questions See All
How to check leakage current of Si-SiO2 wafer?

I want to use the n-type Si wafer coated with a 300 nm SiO2 layer for the OFET device, but for that, I have to check the leakage current of the dielectric layer. how?

07 February 2024 4,115 2 View

What will be the quality of Al2O3 layer in OFET device fabricated through RF Sputtering?

This question is related to OFET devices. Please suggest some answers to this question.

07 February 2024 8,067 0 View

How to extract velocity data of a moving object from a simulation done in Ansys Fluent?

Hello Everyone!! I am currently working on a model for renewable energy harvesting using ocean wave energy in Ansys fluent. I have applied a dynamic mesh and compiled the UDF for motion of a...

30 January 2024 8,896 1 View

How to remove negative volume error in Ansys fluent dynamic mesh?

Hello Everyone!! I am currently working on a model for renewable energy harvesting using ocean wave energy in Ansys fluent. I have a design ready along with a UDF for a moving component. But when...

08 October 2023 5,531 5 View

How can we isolate exopolysaccharide content from cyanobacterial strains?

Is there any method for isolating exopolysaccharides (not the total Carbohydrate) from cyanobacteria?

06 August 2023 4,234 2 View

How can I find or estimate the species specific parameters α and β for application in Beta-poisson model for QMRA?

I am trying to estimate the QMRA for three species of bacteria using beta-poisson model. The literatures that I followed have not reported the α and β values for these 3 specific bacteria, while α...

27 May 2023 5,692 0 View

Q-Exactive calibration error for Mass resolution Dependency too high, can anyone help?

Hi, After performing my annual cleaning on the QE and calibrated, it as passes the positive cal but when performing the basic (negative) Analyzer accuracy it has failed for Mass resolution...

08 January 2023 2,206 1 View

What is the simplest method for hematocrit correction during glucose measurement in electrochemical dry strip technology?

Hematocrit correction during glucose measurement is very important for enhancing the accuracy of measurement in whole blood. As far my knowledge, it done electrochemically either through impedance...

20 December 2022 8,534 0 View

How to distinguish triplet-triplet annihilation band from phosphorescence and TADF?

If an organic molecular emitter shows multiple photoluminescence bands, what tools and techniques can one use to confirm the triplet-triplet annihilation (TTA) band?

18 November 2022 6,879 4 View

Can anyone tell me how to publish RFC standard?

I want to publish a work as an enhanced version of RFC 8180.

11 November 2022 6,235 1 View

Similar questions and discussions
Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

GC-MS retention index prediticon?

Hello experts, Does anyone know any free software about retention index prediction ?

08 August 2024 7,403 2 View

RNA Extraction Using Hot Borate Method No Longer Working?

I've been performing RNA extraction on cotton petiole tissue for a few months now using the method described in the following paper, a derivative of the typical hot borate method...

08 August 2024 9,882 2 View

Can I use a HisTRAP column for affinity chromatography?

I'm working on selecting antibodies against a recombinant protein that has a His-tag. My idea is to first bind the recombinant protein to a HisTRAP column and then use this column for an affinity...

07 August 2024 505 3 View

AUX gas reading problem on QE with full MS and PRM method in one run?

Dear QE-users, In the method where full MS positive mode and PRM mode are used, we always get an incorrect auxiliary gas reading (41 instead of 25). This only happens in this method; other...

06 August 2024 4,953 0 View

Hi, please what is the best tool on Aspen plus that can help me get the best inlet temperature and pressure for cryogenic distillation?

I am trying to recover liquid CO2 from a mixture of 0.6 CO2, 0.3 N2, and 0.1 O2. My aim is to recover about 99% liquid CO2 at the bottom of the column and make sure the amount of gaseous CO2...

06 August 2024 4,611 0 View

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

How can I inoculate a lyophilized anaerobic bacteria into the culture medium without an anaerobic chamber?

There are anaerobic gas pak jars and environment providers in the laboratory that provide anaerobic environmental conditions for the growth of anaerobic bacteria. However, there is no anaerobic...

05 August 2024 4,945 3 View

Why is TLC not a form of partition chromatography?

Why is TLC not a form of partition chromatography and paper chromatography not a form of  absorption chromatography?

03 August 2024 7,035 3 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close