How to prepare 0.02 M sodium phosphate buffer (containing 6 mM NaCl, pH 6.9) ?

Subhadarshani Dhall @Subhadarshani-Dhall

13 March 2024 1 2K Report

how to prepare 0.02 M sodium phosphate buffer (containing 6 mM NaCl, pH 6.9)

Biswajit Jena

Refer to https://www.fda.gov/food/laboratory-methods-food/bam-r61-002-m-phosphate-saline-buffer-ph-73-74

Badges
Science topic

Similar topics
Chemistry
Chemicals
Solvents

More Subhadarshani Dhall's questions See All

Is pH condition change after synthesis of chitosan coated silver nanoparticle?

12 July 2023 6,178 4 View

how we can dry the chitosan coated silver nanoparticle for characterization?

is it possible for sublimation by the help of lyophilizer ? or hot air oven?

03 July 2023 9,601 5 View

Can anyone guide me about air brush technique to deposit the film of CNTs?

Which type of gun/air brush required for this?

25 October 2016 6,643 5 View

Can any one suggest me, simple and effective route to synthesis ZnO and WO3 nanorods/nanoparticles?

Can any one suggest me, simple and effective route to synthesis ZnO and WO3 nanorods/nanoparticles? any chemical route...

30 May 2016 8,406 5 View

Can anyone tell me, how we deposit indium oxide NPs uing thermal evaporator system?

After thermal deposition of Indium , how we convert it Indium oxide with the help of sintering?..

11 April 2016 6,338 3 View

Can any one tell me, How we convert SCCM into PPM in case of gas sensing experiments?

any direct conversion is possible? also, can we change sccm of two gases into percentile?

06 April 2016 3,483 4 View

Can anyone tell me, what type of etchant used to etch Al metal after lithography?

Plz mention name of company... to procurement..

31 January 2016 5,127 3 View

Can anyone suggest to me an appropriate technique to functionalize single layer graphene film?

Actually, i have no idea about the concentration of acids, if i adopt chemical route.. And also no idea about physical route...

03 December 2015 8,288 5 View

Can anyone tell me, why raman bands occur 2000-2300 cm-1 in MWCNTs/SnO2 composite?

i have recorded this spectra on Renishwa by taking Si/SiO2 substrate... is it any noise?

29 October 2015 3,418 5 View

Why do 2G and D+G bands occur in Raman spectra of MWCNTs after functionalization and attachments of nanoparticles?

The intensity of D+G bands increase after the functionalization of MWCNTs

14 September 2014 9,448 2 View

AMAXA Lonza nucleofection lower volume of buffer?

Does anyone tried to do nucleofection with AMAXA by Lonza with lower than recommended amount of buffer in the cuvettes (100 ul)?

07 August 2024 4,616 0 View

Why I can't see any band in SDS-PAGE?

Currently, when I run SDS-PAGE, I don't see any bands at all, even though I used the same material just a day ago and it worked fine.... In our lab, we dilute the 10X running buffer to 1X and...

06 August 2024 5,373 2 View

How to assess the osmotic power of a substance?

Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...

06 August 2024 977 1 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

What is the best blank for nanodrop if I want to read a recombinant protein concentration?

Is it the "elution buffer" or the "dialysis buffer"? Note: I'll be using NanoDrop OneC

01 August 2024 967 3 View

How to check pH of a high strength hydrogel?

We are working on biopolymeric hydrogels. Our system is highly viscous and sticky, and the gel formed are high in strength. We are unable to use pH electrode and pH strip. Please suggest an easy...

30 July 2024 942 2 View

EDTA buffer solution?

Hello everyone! How can i prepare EDTA buffer solution (pH 8.2) to determine GSH levels? Thank you in advance.

29 July 2024 4,374 1 View

Whether i can preserve leaves samples in 2.5% glutaraldehyde in 0.05 M phosphate buffer, pH 7 for coming several weeks for further LM study ?

I want to preserve the sample leaves for the LM study of the stomata and conidia analysis. Whether 2.5% glutaraldehyde in 0.05 M phosphate buffer with pH 7 can be applied for preservation.

29 July 2024 8,560 0 View

Sodium azide in immunohistochemistry?

Hello everyone, A collaborator sent us his protocol in order to be able to use his immunohistochemistry kits. But one step contains PBS + 0.3% H2O2 + 0.1% sodium azide. Knowing the dangerousness...

23 July 2024 6,314 3 View

Can a shoot-through event of a tri-state digital buffer cause momentary Hi-Z state?

// interested in the difference between floating events and short circuits.

22 July 2024 6,565 0 View