Scholarly Recommender System?

Hi, Can anyone tell me any tool or suggestions as i want to seperate conference name from the title of paper? I AM LOOKING FOR CONFERENCE NAME NOT JOURNAL NAME.

10 August 2020 7,934 4 View

Is it possible to apply Multilevel models when data set consists of 3 IVs of categorical nature and 1 or more continuous DVs ?

My data set consists of 3 categorical IVs (1st IV consists of 2 categories, Second IV also consists of 2 Categories and 3rd IV consists of 3 categories).

23 July 2020 952 2 View

Ranking Formula for Research Papers?

Hi I am developing a ranking formula for different levels of users that is beginner,Intermediate and Expert. I am using three metrics for it that is impact factor,h index and citations,We need to...

02 March 2020 4,633 4 View

Can we use petrol for extraction of bituminous?

It may show difference in efficiency but is it recommended or usable method for extraction of bituminous.

27 February 2020 4,446 1 View

What is the reason behind the missing of XRD peaks in sintered composite sample ?

I have sintered Mg3Zn1Ca15Nb composite at 630-degree temperature and measured the phases present in the composite through XRD. But, no phases are detected in XRD analysis. So what can be the...

23 February 2020 9,366 5 View

What are different types of emerging contaminants and their treatment methods?

Emerging contaminants are present in traces in water, air and soil. these can not be removed by conventional treatment methods. ECs are classified on the basis of their causes or sources of...

31 July 2019 1,869 2 View

Why do we use dual band antenna instead of two single band antennas..??

why is dual band antenna at 28/38 ghz more important than tow single band antennas

05 July 2019 8,666 8 View

Is there any other approach available for ARIMA modelling except Box-Jenkins methodology?

Want to directly use non stationary time series without differencing the series.

27 March 2019 7,623 2 View

Do the poly-phenol or other antioxidants properties, sustain at higher temperature levels such as 400 degree Celcius?

Gel extraction from aloe Vera is performed generally centrifugal temperature at various speed. what are the effects of temperature variation on the extraction and properties of gel???

26 January 2019 419 6 View

What are the precursor used to fabricate the biomass derived carbon?

there carbons are used for the production of super capacitor. If anyone know about this, please share information or papers.

26 January 2019 8,980 3 View

Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

Why can't make aluminum nitride film successfully by use sputter?

We use reactive sputtering process to make aluminum nitride film, and want to make c-axis aluminum nitride film on a silicon substrate, but the crystal orientation cannot be seen with...

03 March 2021 7,975 3 View

How to check the uv-vis absorption of nanoparticle by surface plasmon resonance?

I try to check the uv-vis absorption of Indium nanoparticle. Now I am measuring in solution, can I measure it in the form of a film?

01 March 2021 930 3 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

POlymer+DMSO solution and moisture??

What could be the reason of moisture at the sides of Vial when I am preparing my polmyer+DMSO solution for membrane fabrication? What etiquettes I am possibly missing here?

28 February 2021 6,516 5 View

How to prepare a thin polymer film by post-polymerization/crosslinking?

24 February 2021 2,362 5 View

How to delaminate copper in water-based anodes?

Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...

24 February 2021 3,785 3 View

Is is possible to pole with corona poling pellets of the sample material instead of thin films?

As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...

24 February 2021 1,349 1 View

Thermal reduction of graphene oxide.?

I am trying to reduce graphene oxide by thermally but I have no proper information regarding this. Can any one help me regarding the details about temperature and time for the reduction of...

23 February 2021 4,155 4 View

Is there an ideal incubation time of RGO-modified SPCE before subsequent use, i.e., electrochemical characterization or further modification?

I notice that upon washing and air-drying of my RGO/SPCE surface and characterizing again via DPV, the current response towards ferricyanide probe significantly decreases. My worry is that the...

22 February 2021 5,324 3 View