How to make 50mM potassium hydrogen phthalate-imidazole (PI) buffer 5.8 for enzyme assay

Aem. S.S @Aem-Ss

01 January 1970 0 5K Report

how to make 50mM potassium hydrogen phthalate-imidazole (PI) buffer 5.8 for enzyme assay ?

Badges
Science topic

More Aem. S.S's questions See All

How to make chocolate milk ?

we want to produce chocolate milk industrally .Dose anyone have a specific stabilizer formula for this pourpose?

10 July 2024 3,791 1 View

How to perform Galvanostatic/Charge discharge using Wonatech?

Hi, I want to perform Galvanostatic charge/discharge studies using Wonatech SP1 electrochemical workstation. I do not know how to do this. There are two tests showing in this. One is CC/CC test...

06 April 2024 4,286 2 View

Abaqus composite layup is not stacking along the thickness?

Greetings to all. I am trying to make a composite ply sheet made up of 3 material, after assigning properties and visualizing ply stack layer it is NOT stacked along the thickness(which is...

27 February 2024 8,273 4 View

How to retrieve AOD data from MODIS satellite and plot it in 2km * 2km grid?

I want to know the process of datasets extraction which are downloaded from LAADS DAAC and GIOVANNI website.

28 December 2023 667 0 View

Reporting in a linear regression that is bootstrapped?

Hello everyone, I am currently working on my thesis and due to the normality assumption being violated, I am performing bootstrapping for my two simple linear regressions and my multiple linear...

28 November 2023 8,938 2 View

Multinomial logisitc regression probelm- help?

I am writing my bachelor thesis and I'm stuck with the Data Analysis and wonder if I am doing something wrong? I have four independent variables and one dependent variable, all measured on a...

18 November 2023 3,488 14 View

Can someone help with Multiple Smear in Western blot while using DAB developer?

The purified protein only has one band in both SDS and after transfer in ponceu, But when DAB developer is used the entire lane of the blot is getting dark with multiple bands. we are using...

09 October 2023 8,875 2 View

How to index hkl indexes of an unknown material?

I made a nonmaterial with elements Ni, Co, Se, C and O. The compound I attempted is NiCoSe2/GO using required precursors. I tried different literatures and YouTube videos to index the peaks with...

04 September 2023 3,674 0 View

Is it the DPV lines mentioned in below graph is indicating sensing?

Hi I have performed DPV with one of the material against a pesticides. I found the region just after the oxidation peak was increasing with increasing concentration of pesticides. I am quite...

19 June 2023 9,996 2 View

Why the Zre are appearing in negative x direction?

Hi I have measured the corrosion experiment which is shown below. The experiment shows that the Zre values are going in a negative direction. What is the possible reason for this?. Kindly someone...

11 June 2023 3,172 2 View

AMAXA Lonza nucleofection lower volume of buffer?

Does anyone tried to do nucleofection with AMAXA by Lonza with lower than recommended amount of buffer in the cuvettes (100 ul)?

07 August 2024 4,616 0 View

Why I can't see any band in SDS-PAGE?

Currently, when I run SDS-PAGE, I don't see any bands at all, even though I used the same material just a day ago and it worked fine.... In our lab, we dilute the 10X running buffer to 1X and...

06 August 2024 5,373 2 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

How to increase citation in Research Gate?

How to enhanced h-index in Research Gate?

04 August 2024 3,368 4 View

Why results of ROS flurescence are negative as there was no bacteria within?

Hello. I am working on ROS production of two systems: system A is cerium oxide and hydrogen peroxide, system B is cerium oxide nanoparticle, hydrogen peroxide and potassium bromide. I did some...

04 August 2024 5,974 3 View

How to Transform my handy-wavy explanation of why group I/II metals oxides in aqueous solution are basic into a rigorous argument?

I heard an explanation about something being a better proton acceptor or lone pair donor but that doesn't make sense. I couldn't explain in in terms of acid-base theory. The hand-waving way I saw...

03 August 2024 9,918 0 View

What is the ionic radius of Hydrogen anion? And how to know the exact ionic radii of the elements?

I'm trying to calculate the tolerance factors of the hydride perovskite and the value calculated by me and the reported values are contradictory. Need more clarity in using the correct ionic radii...

01 August 2024 2,614 1 View

What is the best blank for nanodrop if I want to read a recombinant protein concentration?

Is it the "elution buffer" or the "dialysis buffer"? Note: I'll be using NanoDrop OneC

01 August 2024 967 3 View

How to make the concentration measurements for the hydrogen absorption/desorption in the metal hydride?

Hello Everyone! I am trying to create a metal hydride system where I am trying to create a temperature control with the emphasis on measuring the concentration of the hydrogen with the hydrogen...

29 July 2024 7,577 2 View

EDTA buffer solution?

Hello everyone! How can i prepare EDTA buffer solution (pH 8.2) to determine GSH levels? Thank you in advance.

29 July 2024 4,374 1 View