I need to simulate a Hyper Velocity Impact upon a sensible plate. I would like to split the simulation in two: firstly simulating the part of the plate near the impact (which is subjected to extreme deformation) in Autodyn, exploiting the SPH method; then starting from the results obtained in Autodyn I will conduct the analysis FE involving the rest of sensible plate.
Thus, I need to know how to use the results of Autodyn (in term of displacements/forces/pressures...) directly as the input of FE analysis, which I will do as a "simple " transient structural analysis, to reduce significantly the computational time.
Thank you for your help!
You could use the Autodyn user`s subroutines. Unfortunately, there are no absolute rules for writing. There are some guides and tutorials.
- Badges
- Science topic