How to export .csv/.xls(x) Files of SpO2 and Nasal Flow from ApneaLink?

15 March 2019 1 3K Report

Hi everyone, as stated above, I would like to know whether it is possible to export data of SpO2 and Nasal Flow in .csv or .xls(x) format from ApneaLink for further analysis.

Thank you in advance, best regards.

Mokhaled N. A. Al-Hamadani

I'm interested in this question too!

Badges
Science topic

More Matteo Bradicich's questions See All

Why am I getting "shark finn"-like signal?

My collegue and I are having hard time to understand what is happening. Basically we have a tapping device that work with Arduino and a pneumatic pump. The pump allows the tapping of two...

04 August 2024 4,662 1 View

Posthoc test lettering in JAMOVI?

Does anyone know of a module for the JAMOVI software that is capable of generating mean separations using the classic letters based on post hoc results (e.g., Tukey test)? If, as I believe, such...

31 July 2024 3,333 4 View

Metallic system in quantum espresso with no smearing. Is this possible?

Hi! I'm simulating a specific material on Quantum Espresso, and I found something strange. Initially I've performed simulations on FCC InAs crystal and I used the Hubbard correction to reproduce...

02 July 2024 9,323 1 View

Can you help me identify Similar Periods in Time-Based Data?

Let's suppose we have a series of time-based data describing a dynamic (e.g., air temperature over the year, measured once a day). Is it possible to apply a statistical technique that allows me to...

05 April 2024 1,591 2 View

How do you call an outcome if you have multiple endpoints to investigate it?

Hello, When you want to investigate exacerbations (outcome of interest) in asthma, you can measure: 1) the incidence rate in the last year (i.e. mean numbers of exacerbations in the last year in...

14 December 2023 9,828 1 View

Does anyone have a recipe for zebrafish aCSF?

Hi everyone, Does anyone have a recipe for zebrafish aCSF that might match the molar concentrations reported by companies like Harvard Apparatus or Tocris (in mM Na 150; K 3.0; Ca 1.4; Mg 0.8; P...

03 December 2023 3,919 0 View

Which statistical test should we use?

Hallo everyone, I need to ask for advice: I am currently doing a research on Carpal Tunnel Syndrome and Ultrasound measurements of the median nerve cross sectional area, in particular I am...

26 September 2023 7,638 0 View

Why do the same PCR products have different weights in the electrophoretic run?

Dear all, Thanking you in advance for your attention, I would like to ask you two questions regarding an electrophoretic run on 2% agarose gel: 1) I did an electrophoretic run of the Real-time...

25 June 2023 7,501 4 View

Which camera should I use for PIV measurements?

Hello everyone, I am working on my Phd on free surface water streams with conda effect. Basically I am acquiring images from above of a rectangular basin in which enters a jet which is then...

22 June 2023 5,089 0 View

How can I delete an article page?

Dear RG staff I'm Simone Seghetti. I'm writing to you for an issue about an article which I had incorrectly uploade (following...

18 April 2023 9,797 3 View

How to learn more about SPSS and its Application?

I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.

11 August 2024 9,101 4 View

Is there a problem with my RNA pellet?

Hello, I am currently having problems with RNA extraction. I am using mouse liver (C57BL6J), and I have extracted RNA from mouse liver before. Before this experiment, my final RNA pellets were...

11 August 2024 7,082 3 View

Can I base on reverse DNA sequences to perform alignment, convert to amino acids and GenBank submission?

I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?

11 August 2024 5,138 1 View

Baseline drift in HPLC? What causes this?

Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!

11 August 2024 3,770 4 View

Text-Communication from the M1 Hand Area using BCI—and then there is Elon Musk?

Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...

10 August 2024 7,180 0 View

Handling Missing Data and Building a Predictive Model with Incomplete Information ?

I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...

10 August 2024 4,005 2 View

Has anyone applied Python in the field of textile engineering for data analysis, automation, or smart textiles?

I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...

10 August 2024 7,429 2 View

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

09 August 2024 7,718 0 View

GC-MS retention index prediticon?

Hello experts, Does anyone know any free software about retention index prediction ?

08 August 2024 7,403 2 View

RNA Extraction Using Hot Borate Method No Longer Working?

I've been performing RNA extraction on cotton petiole tissue for a few months now using the method described in the following paper, a derivative of the typical hot borate method...

08 August 2024 9,882 2 View