How to estimate chemical structure using Mass chromatogram?

More Jyoti Jaglan's questions See All

What are the limitations and challenges of using machine learning for predicting concrete compressive strength in practical applications?

Machine learning (ML) has shown great potential in predicting the compressive strength of concrete, an important property for structural engineering. However, its practical application comes with...

03 August 2024 2,546 2 View

How to quantify Short Chain Fatty Acid in Stool samples of mice?

I am doing experiments in mice model of metabolic disorder. For that I have to do quantification od 3 major short chain fatty acid namely acetate propionate and butyrate. I had earlier tried...

15 April 2024 3,284 0 View

Can Climate Change and Earthquake are interconnected?

Increasing rate of Earthquakes.

04 April 2024 6,766 3 View

FOLD CHANGE calculation for metabolomics data?

I have metabolomics data from a non-targeted approach normalized with internal standards. I have calculated the p-value (t-test), VIP score, and fold change. For that, I transformed the data (each...

23 March 2024 9,663 1 View

Untreated cells are showing high LDH reading than treated cells?

I did LDH cytotoxicity assay on HCT116 cell line with my compounds at various concentrations. After 24,48,72h of incubation, LDH assay was performed according to manufacturer's protocol. My...

10 March 2024 8,521 0 View

I want to test the following hypothesis using Mann -Whitney U Test. Is my interpretation of the result correct?

Null Hypothesis: The recovery percentage of A channel is less than the recovery percentage of B channel Alternate hypothesis: The recovery percentage of A channel is not less than the recovery...

02 March 2024 4,903 4 View

Can anyone suggest how to write results of Kruskal wallis test in thesis?

The following are the results of 4 channels of recovery of NPAs H =21.402153 Chi square value= 7.814727903 , Alpha level= 0.05 P value 0.00008685210 Reject Null? Reject Null

23 February 2024 6,835 5 View

How to calculate local heat transfer and thermal boundary layer in ANSYS Fluent?

I am currently working on pin fin in microchannel. I want to calculate heat transfer and thermal boundary layer of that pin fin at different Reynolds number. Can anyone tell me how to find it in...

25 January 2024 6,611 1 View

Can I use ANOVA to test hypotheses comparing recovery(%) of different channels of recovery?

Collected data of ten years for recovery(%) of four channels of recovery for recovery from NPAs of banks. Want to know if I can use ANOVA to test my hypotheses relating to recovery(%) of any two...

10 January 2024 3,367 5 View

May I know, whether the Journals include reference section while checking the similarity index of a manuscript?

It's an important query regarding the plagiarism checking of research papers.

24 December 2023 6,752 2 View

Strugglling with m6A dot blot any suugesstion ?

I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...

10 August 2024 8,539 5 View

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

09 August 2024 7,718 0 View

The aqueous fraction of the hydroethanolic extract is showing the presence of palmitic acid. What is the mechanism responsible ?

Palmitic acid presence in aqueous fraction

05 August 2024 8,624 4 View

Which solvent is better to dissolve with secondary metabolites extracted from fungi?

I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...

03 August 2024 4,725 2 View

For systematic review data extraction, should I use ITT or PP analysis, and count all randomized participants or only those who completed the study?

I am conducting a systematic review and meta analysis; as I am extracting data I realized there is a consort diagram that shows the number of patients from randomization till end of the study. So...

01 August 2024 9,993 3 View

For the moringa oleifera extract using ethanol as the solvent,what is the alternative method to concentrate the extract other than rotary evaporation?

99% pure ethanol was used for maceration also alternate methods along with the temperature and time to concentrate the extract can be specified

31 July 2024 5,113 4 View

What are the factors that causes the sample to have higher efficacy at lower concentration?

We conducted an antibacterial study of a plant extract. Varying concentrations of crude extract were subjected to microbroth dilution assay. The result showed that only the lowest concentration of...

31 July 2024 8,666 3 View

What Are the Best Alternatives to the MTT Assay for Assessing Cell Toxicity of Colored Herbal Extracts?

I am currently investigating the cytotoxicity of a series of herbal extracts, and like many studies, I have been using the MTT assay to evaluate cell viability. However, I am encountering a...

31 July 2024 193 4 View

How can I extract my bibliography from researchgate ?

how can I extract my bibliography from researchgate ?

28 July 2024 6,737 1 View

What is the relationship between protein structure and N or C terminal tagging choosing?

I want to do 2,3-butanediol dehydrogenase(BDH) enzyme purification to confirm its activity for 2,3-butanediol. Before that, I need to confirm which N or C terminal tagging is better for enzyme...

28 July 2024 366 3 View

Chinaza Godswill Awuchi

Check https://www.utdallas.edu/~biewerm/12MS.pdf

https://science.widener.edu/svb/nmr/citronellal/formula.html

Also check https://www.sciencedirect.com/topics/biochemistry-genetics-and-molecular-biology/mass-chromatogram

https://www.britannica.com/science/chemical-compound/Mass-spectrometry

Jyoti Jaglan

how can I choose sinlge peak out of multiple? is there any particular criteria on the basis of which I select