How to do simulation of magnetic field sensor by comsol ?

More Zahra Jafari's questions See All

I don't know ratio between nitrates and PVA and also i don't know from which kind of PVA (which mw?) I use. dose someone know about?

Hello, I wanna synthesize powder of La0.7Sr0.3MnO3 by combustion route and i will use polyvinyl alchol(PVA) as a fuel and nitrates as precursor materials. but i don't know ratio between nitrates...

08 September 2017 1,988 0 View

Does anyone know how much use ethanol as milling medium in solid state reaction method using ball milling ?

Dear all. I want to prepare La0.67Ca0.33MnO3 powder by solid state reaction using ball mill but i don't know why milling medium should wet by ethanol and how much use it.Can someone help me?

10 November 2016 6,003 4 View

Problems about acousto-optic coupling in Comsol, how to check whether the moving mesh is correct?

I’m trying to reproduce the acousto-optic coupling simulation in the paper Frequency–angular resolving LiDAR using chip-scale acousto-optic beam steering. LNOI(lithium niobate on insulator) is...

13 August 2024 9,795 0 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

Why is the molecule's orientation with an electric field affect polarizability?

Why is the molecule's orientation with an electric field affect polarizability? Electrons are diffuse enough to be independent with respect to orientation and effect of electric field on...

03 August 2024 7,843 1 View

Why do paired electrons atoms produce no magnetic field lines?

If you think of electrons with spin as bar magnets, you know bar magnets of opposite polarity as long as they're not occupying the same spatial location don't cancel out each other's magnetic...

03 August 2024 3,927 2 View

How to correctly use the UTE and ZTE pulse sequences in Bruker's ParaVision software?

I am using a Bruker 600M solid-state NMR spectrometer with a Micro 2.5 microimaging system. The test sample is a tube of 1M LiCl aqueous solution, and the nucleus detected is 1H. I am trying to...

01 August 2024 9,227 1 View

Mossbauer spectroscopy Co0.6Mn0.4Fe2O4 MNPs?

Following curve related to Co0.6Mn0.4Fe2O4 Magnetic nanoparticles with extra phase a-Fe2O3. I will appreciate to help me to interpretation this spectroscopy, especially the blue line.

31 July 2024 9,140 2 View

With attention to past my experiences on field geology I think any mineral ores can be in any geology area. Are you agree with me?

I want to know more about ore deposits in world.

27 July 2024 3,827 4 View

Does it exist some special technique for cutting ceramic membranes for Cross-sectional FESEM images?

Does it exist some special technique for cutting ceramic membranes for Cross-sectional FESEM or SEM images?

25 July 2024 5,482 2 View

How to get LP fiber modes directly from Comsol?

Hi there, I'm new to modelling with comsol. I would like to ask if it is possible for comsol to output linearly polarized (LP) modes? I tried modelling a simple single mode fiber with an enlarged...

23 July 2024 4,019 3 View

Is it true that there is a physico-statistical meaning to the constant π other than circular geometry but the iron guardians of the SE deny it?

We assume that there is a physico-statistical meaning to the constant π other than circular geometry, but the iron guardians of the Schrödinger equation deny this. The iron guardians of the...

22 July 2024 4,285 9 View

Markus Schneider

I am afraid Comsol will not be able to reproduce the properties of manganites. The complicated electronic phase transitions on which CMR is based cannot be transferred into "simple" partial differential equations.

Vasanthan Devaraj

Probably you can try Infineon tool

https://www.infineon.com/cms/en/tools/landing/sensor.html

Zahra Jafari

Hello M. Schneider

can I ask you what kind of program do you offer for simulation of magnetic field sensor?

It depends on what you want to do. Please describe your project.