Nowadays, I have learned to use Petrel from Schlumberger.
But, cannot know and find any button or tool in the program for reserve estimation.
So, If you know the point, please give me the knowledge and advice.
I am going to wait for your answer.
Have a good day!!
It depend on what stage of field development you are looking at, and the data set at your disposal. Is it a first pass volumetric estimation, which comes with a lot of uncertainty, or that which require modelling ?
Hi. Ogbamikhumi.
Thank you for your remaining answer.
I`m a novice to use the program.
I just made a simple grid as examples by using reservoir engineering books of Schlumberger without specific dataset.
At first, I want to make grid modeling about a gas reservoir.
after then doing reserve estimation is the last goal for me
But... I cannot find any tool for reserve estimation.
You have to find out the volumetric function and put the porosity, water saturation, area. Than press the volumetric calculation bottom.
Dear @Daemo Lee,
By reservoir simulation, I guess you mean reservoir modeling with various realisation to choose from... Before you can generate a reservoir model, you have to first do due diligence to your petrophysical analysis. Then you go ahead to do seismic-well-tie and go ahead with your seismic interpretation.
It is after this you can go ahead to create grids, chosing your simulation statistical method and generating your models..
However, it is good to note that, the outcome of your model majorly depends of the data input.
I hope this helps to answer your question.
Regards
Olatunbosun Kafisanwo
- Badges
- Science topic
- Similar topics
- Computer Science
- Program