How to do DPM (Nanoparticle dispersed in air) for a 90 degree bend using LES?

More Kaviarasu Chinnaiyan's questions See All

DNA isolation methods - DNA yield is lesser in micro wave method then in salting out method and commercial kit method. Why?

We are isolating DNA from wax embedded Squamous cell carcinoma (SCC) tissues. We take tissue sections and isolate the DNA from that. We following 3 methods for a comparison study. Those methods...

24 November 2017 8,482 0 View

How to induce nephrotoxicity in Wistar rats?

I wish to induce nephrotoxicity in Wistar rats by using nicotine. I would like to know how much concentration of nicotine to be used for the induction to animal. It would be thankful If u could...

09 November 2017 4,397 0 View

During DNA isolation how do u make sure that you have isolated only the DNA not RNA?

While isolating DNA how do we make sure that we have isolated only the DNA at the end not RNA? At which step the DNA alone get separated and which buffer and composition is used for that... Thank You

24 October 2017 7,255 4 View

In LES method, how to incorporate the surface roughness for pipe?

In flow analysis for rough pipe using Large Eddy Simulation, how the roughness height and roughness constant value can be incorporated. Is it possible?....

26 February 2017 5,486 5 View

What is the thermophysical properties of copper oxide nanoparticle ?

Looking for the thermophysical properties of copper oxide for size greater than 50 nm in diameter.

28 January 2017 6,237 2 View

Can any one tell me the important genes involved in adipogenesis regulation during type-2 diabetic condition?

I would like to know the important genes involved in adipogenesis regulatory mechanism during high fat fed condition in Wistar rats or during type-2 diabetic condition...

20 May 2014 8,617 4 View

How to calculate the gain value Kp and Ki for the current controller of Matrix converter?

I have attached the block diagram of the control. I'm trying to implement the SPWM switching sequence and control the matrix converter(Three phase to single phase). The output of the Matrix...

01 January 1970 7,562 2 View

Stability of the Solar System: Insights from Einstein’s Equations ?

The stability of the Solar System is a complex subject that blends the classical framework of Newtonian mechanics with the modern insights provided by General Relativity (GR). Understanding this...

07 August 2024 2,569 1 View

How to determine positive-stained cells in FACS? Use isotype or unstained control?

To compare positive and negative cell populations in flow cytometry, should I compare unstained cells with antibody stained cells? Or with the isotype control? Most papers show comparison with...

06 August 2024 6,728 6 View

Why do we equate male and female arousal?

Women, on the other hand, can become physically aroused (increased blood flow in the reproductive organs) without becoming psychologically aroused even in the slightest. (Robert Weiss)

05 August 2024 9,537 2 View

How to start a Molecular Dynamics Simulation?

Is it possible to conduct a molecular dynamics simulation to see the effects of a specific carbohydrate on the structure of lipids (e.g., micelle structure)? I am a beginner in this field and plan...

03 August 2024 3,371 3 View

Which will be the best software for the Hydration shell analysis with molecular dynamics?

I am using a windows system, what software I should use for hydration shell analysis with molecular dynamics?

02 August 2024 3,143 4 View

How to make a Lateral flow control line more uniform?

We have a lateral flow test on Sartorius 140 NC. The conjugate is gold-monoclonal antibody. Using different control lines (GAM, protein A, protein G) we get a very strong leading edge with reduced...

31 July 2024 4,510 3 View

Posthoc test lettering in JAMOVI?

Does anyone know of a module for the JAMOVI software that is capable of generating mean separations using the classic letters based on post hoc results (e.g., Tukey test)? If, as I believe, such...

31 July 2024 3,333 4 View

Suggestions for the Annexin V Positive Control ?

Hello everyone, I am currently using washed human platelets to stain Annexin V as a procoagulant marker. Additionally, I am staining with PerCP-CD61 to identify platelet cells. So far, I have...

29 July 2024 8,624 1 View

CAD File of human's & rat's respiratory airways ?

Dear all, I am working on particle deposition in human's & rat's respiratory airways using CFD and I am looking for the 3D CAD file for my simulations (STEP or IGES format). If somone has such...

29 July 2024 1,092 2 View

How to restart MD without using checkpint file in GROMACS?

Dear All Gromacs User I would like to restart MD without using checkpint .cpt files? I heard there is a way for acheiveing this. Any input and sugegstions are most welcome. Thanking You Budheswar

29 July 2024 3,084 8 View

Zoubair Boulahia

Hoping this helps you. Good luck.

Filippo Maria Denaro

To tell the truth, owing to the very small lenght scale, I don't think that in nanofluidic the turbulence is the main characteristic issue. Therefore LES is a tool somehow not suitable for such flow problems. Why don't you solve directly in DNS?