hello dear community,
I'm doing a static structural analysis in ansys apdl but i didn't know how to define a remote load. The load is placed at one place and i want that its effect be transfered to surface nodes using remote load option. can you help me please?
Hajar Rhylane
1. Identify the remote location: Determine the remote location where you want to apply the load. This location can be specified using a node, element, or coordinate system.
2. Define the remote load: Use the *CLOAD command to define the remote load. Specify the appropriate options and parameters based on your specific load requirements. Here's the general syntax of the *CLOAD command:
````apdl
*CLOAD, Lab, Lab, Value
```
- `Lab`: Specify the label of the remote location where the load is applied. This can be a node label, element label, or coordinate system label.
- `Value`: Specify the load value or expression to be applied at the remote location.
Note that the `Lab` argument can be a single label or a range of labels, depending on the type of remote location you are using.
3. Repeat as needed: If you have multiple remote locations or different load values to apply, repeat step 2 for each remote load.
4. Generate the load: Finally, issue the *SOLVE command to generate the remote loads and solve the analysis.
- Badges
- Science topic
- Similar topics
- Computer Communications (Networks)
- Simulators