Resistivity of PVD TiNx thin films vs. N2 flow?

In the PVD of TiN thin films (~100A), I've found the resistivity of the TiN films dropped from ~100 to 60um*cm with N2 flow increasing up to the metallic mode ending point; then the resistivity...

21 February 2021 1,864 2 View

Do you have some articles to recommend about comparative experimental study about gas and water flooding with oil reservoirs?

I would like to know in the oil extraction, which is more efficient: gas flooding or water flooding? Will water flooding be more efficient in hydrophilic reservoirs with capillary...

29 December 2020 3,471 3 View

What does this PZC data mean?

I measured different kinds of catalysts which were dispersed in DI water.I firstly added certain amount of HCl and then used NaOH to titrate and measure the pH value. What does this result mean?

27 December 2020 5,728 4 View

How to inhibit the ion conversion between Mn4 + and MN2 +?

Dear scientists, I have a question to ask you, it is known that Mn4+ is beneficial to the soil, but part of Mn4+ in the soil is easy to be converted to MN2 +, is there any way to inhibit its ion...

21 November 2020 1,200 5 View

Failure in using Gene Pulser Xcell (Biorad) ?

02 October 2020 8,642 1 View

Hi everyone, how can we remove the snow-covered areas in global scale?

We obtained the global results using remote sensing reanalysis dataset. But the snow-coverd areas should be removed (like the blank area in the picture below, sources: Purdy et al., 2016). Does...

20 September 2020 3,463 5 View

How to set the fluent simulation species transport density item?

I use fluent to simulate species transport. The medium is sulfur hexafluoride and air. There is a density item under the mixture, and there is also under the fluid. Is there any difference between...

29 July 2020 7,414 4 View

How to detect brown pigments generated in red wine aging process ?

During aging or storage, the concentration of monomeric anthocyanins decreases rapidly, while low level of polymeric anthocyanins generates, and the color of wine turns brick-red gradually. In...

17 July 2020 6,032 4 View

How to calculate mode overlap ratio in Comsol ?

As is shown in attachment, there is hybrid plasmonic waveguide (HPW) and dielectric waveguide (DW), I want know how to calculate mode overlap ratio to evaluated the mode distribution similarity...

14 July 2020 2,275 3 View

Is there any organic solvent for MnCO3?

Since that my experiment could not be proceeded in aqueous. Anyone who know is there any organic solvent for MnCO3, the concentration could be as low as several mg/mL. Thanks

02 July 2020 9,654 19 View

error in running a model in Abaqus

Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1

17 August 2021 0 0 View

error in modelling model in Abaqus

Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1

17 August 2021 0 0 View

MGL tools

20 June 2021 0 0 View

i have some problem with chtMultiRegionSimpleFoam

--> FOAM FATAL ERROR: Maximum number of iterations exceeded From function Foam::scalar Foam::species::thermo::T(Foam::scalar, Foam::scalar, Foam::scalar, Foam::scalar (Foam::species::thermo::*)(Foam::scalar, Foam::scalar) const, Foam::scalar (Foam::species::thermo::*)(Foam::scalar, Foam::scalar) const, Foam::scalar (Foam::species::thermo::*)(Foam::scalar) const) const [with Thermo = Foam::hConstThermo >; Type = Foam::sensibleEnthalpy; Foam::scalar = double; Foam::species::thermo = Foam::species::thermo >, Foam::sensibleEnthalpy>] in file /home/ubuntu/OpenFOAM/OpenFOAM-4.1/src/thermophysicalModels/specie/lnInclude/thermoI.H at line 66. FOAM aborting #0 Foam::error::printStack(Foam::Ostream&) at ??:? #1 Foam::error::abort() at ??:? #2 Foam::heRhoThermo >, Foam::sensibleEnthalpy> > > >::calculate() at ??:? #3 Foam::heRhoThermo >, Foam::sensibleEnthalpy> > > >::correct() at ??:? #4 ? at ??:? #5 __libc_start_main in "/lib/x86_64-linux-gnu/libc.so.6" #6 ? at ??:?

24 March 2021 0 0 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

After a reference from Int J Body Compos Res, can any body help?

Hi, I am after the reference below, my library says it cannot obtain a copy either locally or internationally, any help appreciated! Chris Wang ZM, Heshka S, Wielopolski L, Pi-Sunyer FX, Pierson...

03 March 2021 6,193 1 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View