Hello,

I am trying to form a pellet of PMMA particles. I have tried centrifuging for 1 hour at 26000 RPM (highest the centrifuge I have will go) but the particles do not form a pellet they just clump/form strands thoughout the liquid.

I have also tried in a 1.5mL eppendorf (narrower tube) only going to 15000RPM max speed for 1 hour but the particles form a layer at the top.

Not sure if these particles are impossible to form a pellet or if there is anything else I can do?!

I have about 20% particles to water ratio and am using a 1mL volume in a centrifuge vial that is quite high diameter (compared to eppendorf) at around 1cm diameter.

Thank you.

More Theatin van Leeuwen's questions See All
Similar questions and discussions