How to calculate amount of water to be added for solvent assisted crystallization for zeolite synthesis?

17 May 2017 0 2K Report

In solvent assisted crystallization, the zeolite precursor gel is dried and then the solid powder for of the same is cooked by steam. i want to know how to calculate the amount of water required. I want to prepare zeolite BEA by this method.

Badges
Science topic

Similar topics
Entomology
Resistance

More Kamlesh Tayade's questions See All

How to dissolve selenium nanoparticles powder?

After successfully synthesizing selenium nanoparticles from plants using water my next objective is to assess their antioxidant activity. However, I encountered an issue during the drying process...

18 January 2024 3,156 3 View

Why there is need to used catalyst during nanoparticles synthesis?

Good evening everyone I am working on green synthesis of selenium nanoparticles from leaf extract. The research article mentions that during selenium nanoparticle synthesis, ascorbic acid should...

24 September 2023 4,015 2 View

Why ascorbic acid used as standard for ABTS assay?

ABTS can dissolved in both water and organic solvent. for ABTS assay we can used trolox catechin and ascorbic acid as standard, but mostly ascorbic acid used as standard, and why. why ABTS assy...

09 July 2023 3,455 3 View

How to calculate plant extract concentration (that we want to use to perform experiment like 1mg/ml-5mg/ml) from mother plant extract?

i want to use 1mg/ml to 5mg/ml concnetration for antioxidant assay. my total drug concentration (mother drug ) is 12mg. how to calculate 1-5mg/ml con. from mother drug if total reaction volume is...

30 January 2023 9,656 2 View

How to calculate the standard deviation for total phenolic content?

i want to add my data on abstract for my research paper so how to calculate and plot the values in that and also from which value we have to calcualte the standard deviation

22 December 2022 7,017 1 View

How to calculate resolution from if retention factor and plate number only given?

coumn length is 50 cm and unretained marker takes 2 min to be detected. calculte the resolution for the peaks (A-B, B-C) how long must the column be in order to have baseline resolution? assume...

24 November 2022 8,732 1 View

How to calculate IC50 value for nitric oxide scavening assay?

i have done triplicate experiment for nitric oxide assay and i take 25-225ug/ml concnetration. and i got 3 absorbance value for each concnetration. but dont understand how to calculate IC 50 value...

01 September 2022 5,792 1 View

Why sometimes control not showing colour during experiment?

i am doing metal chelation assay for that i used iron (II) Chloride tetrahydrate and ferrozine. i take 0.1 ml iron (II) chloride tetrahydrate in test tube and added 0.2ml ferrozine as a control...

18 July 2022 3,301 0 View

I am doing hydrogen peroxide scavenging activity of plant extract . I am using 1/50 dilution of extract so do I need to take pure or diluted extract?

I am using 1/50 dilution of (50-250 microgram concentration) and 3 ml of H2O2 but absorbance of sample continuously increasing. Or some time negative absorbance also getting I don't understand...

15 April 2022 6,221 3 View

How to prepare 43mM hydrogen peroxide from 30% hydrogen peroxide chemical ?

Give me details calculation.

03 January 2022 8,346 1 View

Who of all of you will help TPEOM to re-originate the Earths atmosphere to it original 5 atmospheric elements/gases?

Global ‘Weather’ has stopped, as ‘aqua thermionic instituted by the ‘Global thermo atmospherics has instituted global thermodynamics of 120º C + and thus all waters are, or have boiled into a...

06 August 2024 8,716 0 View

How to understand this crystallographic phenomenon of low temperature crystals in zeolite?

During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...

06 August 2024 726 3 View

Who of all the Global Scientific community will help me Prof. Dr. Yoshida make way for TPEOM, MEC ~EMC to return the atmospheric gases to the norma ?

TEP presentation caption (The Environmental Project) Re: Why should Washington’s DC, or any country government point of location think of as nowadays of as to being 'tomorrow as to come! if it...

03 August 2024 2,484 1 View

Is it possible to improve the reforming section of the Haber-Bosch process without using air separation units?

A typical reforming section in a large-scale Haber-Bosch process (Figure 1) comprises two reactors. A mixture of methane (CH4) and steam (H2O) is fed into a primary reformer to produce syngas via...

01 August 2024 7,051 5 View

I have calcined my catalysts without flowing air from the compressed air cylinder will there be any problem with my reaction if i use that catalysts?

FYI Catalyst is MFI zeolite Si/Al = 140,25.40.11.5,15 I am using this catalyst to study methanol to DME conversion

25 July 2024 2,486 2 View

I want to buy Hydrothermal Synthesis Autoclave from any European company. Can anyone suggest any company inside Europe?

Thanks

22 July 2024 1,143 3 View

Hi dear researchers, do you suggest the best and shortest path for chemical synthesis and green synthesis of magnetite(Fe3O4)?

Suggest the best and shortest route for the chemical synthesis and and green synthesis of magnetite(Fe3O4) The chemical synthesis should contain the least dangerous chemicals along with full...

21 July 2024 2,476 2 View

Im trying iodination of an arene, but only getting black precipitates, is there anyone with iodination experience who can advise?

Organic Synthesis. My student has been trying iodination of arenes (our goal is to iodinate p-phenylenediamine) following these literature procedures: 1. Synthesis 2004, No. 11, 1869-1873 using...

16 July 2024 6,630 1 View

What could be the possible reason that sintering of polycrystalline diamond fabricated with tape casting has suddenly started failing?

I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...

16 July 2024 3,212 5 View

How to define a zeolite structure with rigid framwork?

Dear Gromacs users, I would like to simulate a zeolite-water system. In different literature, it is suggested to consider a rigid framework of zeolite to decrease the computational cost. I would...

15 July 2024 4,590 1 View