Hello everyone
One of the most common defects in 3d printing, especially in the FDM process, is the lack of good bonding between printed layers. therefore, to achieve good bonding between layers, what is your suggestion to overcome this problem?
Best regard
Dear Harish Kumar Banga
Thank you so much for your kind contribution.
Have part at furthist place on tray if possible from Nozzel home to allow time for layers to set
Dear Vishal Ashok Wankhede
Thank you for your contribution, but increasing the temperature with no limitation will result in changing the mechanical properties and material structure which harms the mentioned properties on the fabricated part.
Dear James Robert Woodman
Thank you for your reply, this is a good point, with increasing the moving distance to allow the layers to have good bonding, but this action will affect other crucial parameters such as manufacturing time, cost, and even dimensional accuracy. On the other hand, does "the increasing time" works on every material?
- Badges
- Science topic
- Similar topics
- Computer Communications (Networks)
- Simulators