What kind of blank should i use to tar the UV? I just want to mesure metal concentration before and after adpsortion process adding ferrite nanoparticles.
wouldn't it be better to use flame atomic absorption spectrophotometry instead of UV/Vis? UV/Vis would be only qualitatite, and not quantitative characterisation method here - and you want to measure concentration...
It is better to use Atomic spectrometer, or ICP-AEO instruments other than using UV-Vis. Specially for low metal concentrations.
You use UV-Vis for some ranges of metal concentrations. However, this will be time consuming since you will use specific reagents (e.g. ligands) for determination of those metals. It will be time consuming to carry out adsorption experiments then for metal concentration determination you have to do further experimental work to get the concentration of the metal after the adsorption process.
Thanks a lot , the fact is that i need to plot the isotherms adsorption langmuir or freundlich to determine the behavior of adsortion in time or pH changes . so then i need to use reagents to find the ABs samplelike a normal metal mesurement ? on a UV-VIS?